the glue does not lessen the expansion of the wood. the glues elasticity allows the wood to expand and contract as needed. If there are areas without proper bond, the boards could peak or lift because the glue isnt holding them down. but will they ? maybe and maybe not .. its a crap shoot ... who knows?

Bead blaster concrete surface prep. They can be rented.

Both purchased at Floor and Decor Outlet, but the wood was special order from this company: http://www.urbanfloor.com/Maple-Natural.html The installation instructions for the wood floor don't mention a glue with pad method. I'm thinking it's more of an option to think about for sound transfer to a lower living area, but I'm on slab on grade. Here are the instructions: http://www.urbanfloor.com/downloads/urbanfloor_installation2011_web.pdf Here is the pad: http://www.flooranddecoroutlets.com/s54200049.html "Eco Ultra Quiet Premium Acoustical Underlayment"

I found this on https://www.gsa.gov/portal/content/113602 Removing Linoleum Adhesive From FloorsProcedure code:965001SSource:Ohj - Shirley Maxwell & James C. Massey, 9/30/92Division:FinishesSection:Resilient FlooringLast Modified:08/02/2016 REMOVING LINOLEUM ADHESIVE FROM FLOORS PART 1---GENERAL 1.01 SUMMARY This procedure includes guidance on removing the mastic adhesive left behind when linoleum flooring has been removed. Linoleum flooring was very popular from 1863 to 1974. It was used historically as an original floor treatment in some GSA buildings. Linoleum's chief ingredient was linseed oil, pressed from flax seed, which became a tough, elastic material when exposed to air. The process essentially consisted of mixing linseed oil and gum with ground cork or wood flour, and pressing it onto burlap or canvas. It was then glued down to concrete or wood floors using a mastic cement. See "General Project Guidelines" for general project guidelines to be used along with this procedureThese guidelines cover the following sections: Historic Structures Precautions Submittals Quality Assurance Delivery, Storage and Handling Project/Site Conditions Sequencing and Scheduling General Protection (Surface and Surrounding) These guidelines should be reviewed prior to performing this procedure and should be followed along with recommendations from the Regional Historic Preservation Officer (RHPO). PART 2---PRODUCTS 2.01 MATERIALS Clean, potable water Vinegar Citrus degreasing solvent such as "Limo Sol", or approved equal. Dry ice Chemical solvent such as isopropyl alcohol, paint thinner, xylol, lacquer thinner, or paint stripper. 2.02 EQUIPMENT Heat lamp or hot-air gun Putty knife or scraper PART 3---EXECUTION 3.01 ERECTION, INSTALLATION, APPLICATION NOTE: A waterproof glue is usually applied at the edges and seams of the linoleum; the center of the felt layers is usually attached with a water soluble paste. Soak the mastic area in hot water for 20-60 minutes or until soft.\ If this is not effective, try adding vinegar or high-strength citrus degreasing solvent to the water and then soak for 20-60 minutes until soft. If mastic still will not soften, try applying heat to the surface using a lamp or hot-air gun. -OR- Try freezing the mastic with dry ice to break the bond with the substrate. If no other methods are effective in softening the mastic, test a chemical solvent on the area. NOTE: Be sure to test in an inconspicuous area to determine appropriate chemicals and strengths before proceeding with cleaning. Scrape away the softened mastic using a putty knife or garden edger. END OF SECTION interesting................