Using the proper blade, yes they can be cut on a wet saw. As for using the bigger pieces and making smaller ones from them, the only thing I'd emphasize, just as with ceramic, is making sure you have 4 cut edges on each piece. otherwise it'll stand out if one or two edges are factory, and the others are cut.

HI-old thread but wondering if there are any new product recommendations for honed marble? I would like to seal our marble pre-grouting. Then post-grout too unless that is not recommended?? Also-Is there any downside to sealing the marble before it is applied to the wall? Thanks very much!!!

Bill, I don't have a digital camera but I will try to borrow one from a friend and post some pictures ASAP. Thank you so much for your help! Karen

Kendog-- As to the first two choices, I think either one would aork aestheitcally speaking. It would really be a matter of which look YOU like best. We're planning to use pencil rail around our niches as well as above and below the stone and glass liner. Would it look best with pencil around the window as well or could we just overlap the tile there? I would NEVER just overlap the tiles. Being you're going to use the pencil liner for trimming the niche, I don't think it would look out of place if you were to trim out the window as well. The pencil trim has a higher profile than the tile. Should all of it be cut down at the back to make it more flush with the tile if we use it to cover the edge where the tile meets the wall? No-- it's MADE to have that kind of protruding profile. Trim will be needed on the opposite wall where the half wall ends or maybe we could try to bullnose this with a router? The color of the tile edge nearly matches the color of the tile face. Nearly isn't close enough. Either it's exact, or it's not good enough. If you'd rather not use the pencil liners there, I'd use one of Schluter's bullnosing strips. as for the curb, you could always use a marble threshold, thereby elliminating the need for bullnose. Not sure about yours, but most curbs, after backerboard and tile, are about 5 1/2" wide, and a 6" wide threshold set flush to the tile on the outside of the curb, will give you just enough of an overhang on the inside to provide for a nice drip edge. This will do a couple of things for you. First, it'll provide another layer of protection for the curb. Secondly, it'll provide for a nice flat surface for the shower door to sit on, and third, it looks alot nicer than two back to back bullnose pieces. Like this: The floor is about 18 square feet. Do you think it would work well if we cut our wall tile into 4 inch squares to use for the floor? Could we just sand the edges to make them smooth or would we need to use a router? You COULD cut them down, but if the floor isn't perfectly flat, you could end up with uncomfortable edges under your feet. Again, unless the face and edge of the tile look exactly the same, you don't want to use ANY kind of abraiding process (router, sand paper, grinder, polishing wheels) that will show in the finished product. Our tile is rectified porcelain and we'd like to use 1/16 grout lines if possible. If it's rectified, that shouldn't be a problem.