Questions about Brands of Deck Stains
Comments (6)
pgpw
10 years agoAs a professional contractor there are several factors when deciding on a stain and the process used. Before applying a new stain, the existing stain needs to be removed. If its the same type of stain with the same color and its completely run its course, (usually within 2-3 years) then you can just clean and re-apply over that existing stain. If your changing colors or type of stain, it needs to be completely removed. The best method for applying stain is the old fashion way, by brushing. I dont recommend rolling or spraying for three reasons. One, the prep time needed with taping off and covering areas etc. which can take several hours. Two, when rolling or spraying you have to back brush anyway so the labor time spent is just as long and three, it simply looks much better. Always try to stick with oil based semi-transparent stains. They are the easiest to remove and re-apply, they look the best and provide the best type of coverage for both UV and water protection. Finally, the best overall professional grade wood preservative or sealant is TWP. Comes in several colors, provides a lower VOC and applies like warm butter.
The cleaning and prep process is more important than applying the stain itself so be sure you properly clean the wood with an oxygenated bleach (DO NOT USE CHLORINATED BLEACH). Its a powder form that can be easily mixed into a 5 gal. bucket of water. Spray on with a garden sprayer, let dwell about 15-20 minutes then rinse off at low pressure with a pressure washer (800-1000psi). Second step is to neutralize the cleaner with a wood brightener. Spray on with a garden spray, wait 5 min. then rinse off. You will be amazed that when you apply the brightener wood will literally lighten in front of your eyes. This brings the wood back to its natural PH and that is a critical step often missed. After you have rinsed (and be sure you rinse thoroughly) let dry for 48-72 hours then apply the stain. ONE COAT ONLY! Today's stains only need one coat applications especially oil based stains. Hope this helps...good luck with your project!
Here is a link that might be useful: Professional Power Washing Contractor
WalnutCreek Zone 7b/8a thanked pgpwRelated Discussions
New cedar deck stain questions
Comments (0)Between life, work, weather and inexperience, my new 20' x 16' cedar deck has taken me a year to build. The horizontal boards were installed last November. We would like the deck stain to look like similar to this except with white vertical rails too. It doesn't have to be quite as orange but we like that overall look. We hate grayed decks and solid stains for the deck boards . Here is the current color of most of the deck. The step and rail were built in the last 2 months, showing the oxidation. *Sanding* 1) Horizontal surface- after cleaning the deck with the recommended agents, should I sand or power wash the cedar deck to reclaim some color? Or is that unnecessary, problematic and or overkill? 2) If no to sanding/power washing overall, is it ok to use 80 grit Sand paper to fix a few trouble spots? A few 20' boards stuck out of the wood stack and grayed unevenly by August (like a wicked sock tan). I saw some warnings about sandpaper closing the pores of the wood. *Stain choice* 1) What stain would you recommend for the deck boards? I was leaning towards Armstrong Clark Wood Stain. 2) We want a solid white stain for all vertical boards ( treated posts, cedar risers, balusters & rail boards). We'd prefer to avoid the flaking and sanding of paint and some stains. If we apply enough coats can we achieve a vivid, strong white? Here is an early sketch of the design (except it won't be this dark and the top rail is continuous) : *Temperature* Naturally rain is a concern for staining, but does it matter if it is 85-95 degrees when staining vs 70?...See More1 year mark on new deck, a few staining questions
Comments (0)I rebuilt my front porch last summer. I used 5/4" American Mahogany Tongue and Groove. I let it weather for 2 months and then applied a standard deck sealant. Well, now we are looking at staining it to get the darker color of the mahogany back. My questions. 1) Do I need anything other then a cleaner and a stiff brush to do the initial cleaning? Any recommended cleaners other then restore-a-deck.com? 2) Any recommended tools/methods for removing light graying of the deck? I have a pressure washer with adjustable PSI, but I'm hesitant about using it for this project. This is the same pressure washer I used to blast a 4 foot long hole for a conduit under a walkway, so using it on my deck makes me nervous. 3) For application of the stain, is a sprayer the best way to go for even coating? 4) I have a rear porch that also is in need of some restoration (it's at least 30 year old mahogany). Am I best off pressure washing that? I don't mind experimenting on the back as it's just straight nailed mahogany and not tongue and groove. 5) Any miscellanous pointers?...See MoreQuestion about sealing outside Deck
Comments (5)Hello, I think you can spray the sealer on Pump Up Garden Type Sprayers. If you are sealing over a previous failed finished you will need to remove the old finish first. Sodium Hydroxide Based Strippers will remove most oil stains and sealants (Delco's DSR-50). Testing is required with strength and dwell time because of the variation in the quality of the old sealant plus degradation due to time and weather. You need to use the stripper as weak as possible and you can increase dwell time by covering the stripper with plastic sheeting. It is not unusual when removing stains for it to take two or three cleanings....See MoreDeck Stain Question
Comments (1)I used semi transparent Arborcoat on my deck rail and pergola in the Caribbean four or five years ago. It gets full sun all day every day except when we have storms and I am amazed at how well it's held up. As I recall, we had to apply 2 coats in a few spots where the lumber sucked it up, but no clearcoat at all. As for maintenance: I hose it off occasionally. The turquoise Aura I put on the adjacent walls the same week still looks like the day I put it on, too. (full disclosure: we own a BM dealership, but I was reluctant to use two new products the week we got them in because the BMoore stain & paint I'd used for years was really good. "But we have to see it" said my husband and I'm thrilled with both.)...See More
nerdyshopper