skip to main content

How to bump out the sink cabinet...

15 years ago

I'm keeping most of my existing cabinets but changing a few out so I'll need to take the cabinets out, then re-install. One cabinet I'm keeping is the sink base. It does not have a bump out now but I think I'd like a 1.5" bump out (like ni 2006) to add a little pizazz. Can I do this by using the same base and simply pulling it forward from the wall 1.5" and adding the decorative molding on the front? I will be replacing the counter tops too.

Thanks.

Sort by:Oldest

Comments (9)

jb1176
15 years ago
Will your water supply and waste drain pipes have to be extended?
L H
Original Author
15 years ago
I just measured. the pipes are 2" from the back of the cabinet.
Related Discussions
Help with tiling sink wall/ bumped out window area
Q
Comments (10)
A couple more thoughts.. If you use cap type moldings, would ou use it for all four sides of the window? That would make sense but I am not sure if fireclay makes capped corner pieces. Have you thought about using a smaller section of your countertop material for the windowsill? You mentioned a new cabinetry enclosure for the new fridge. Will it have crown molding on the side and front. The side molding on the window side will have to line and match the molding on top of your existing cabinetry to the left of the window. The gap between your window and the molding will have to be the same on both sides I think. I like the contrast between the painted wall and the moldings and the window trim. Ne thought is to just do a 4 or 5 in baseboard type short backsplash that will die into the window trim and use a window sill of the same material as the countertop. On the right, the short backsplash would die into the fridge cabinet and the top of the fridge cabinet with with similar molding will tipoff the area nicely. I am not sure if you are following what I said :) This post was edited by GWlolo on Fri, Jan 25, 13 at 15:54
...See More
What is the reason for the bumped out sink?
Q
Comments (21)
I have read of several on Ikea Hackers site that have modified the Domsjo sink by cutting more holes and/or undermounting. I've got the double bowl version and it has runnels on the back so might not look good undermounted. For just bumping it as a drop in, the other problem is the back has no lip, so if you bump it you'd have the counter simply butting up to the back of the sink, not going under it. This is the sink sitting in the cabinet just to make sure we had the back cut correctly. The counterop actually overlaps the edge of the cabinet and the sink sits on top. We added extra support for the sides of the cabinet to give the countertop a bigger surface to sit on.
...See More
Q: Fillers/Cabinets Adjacent to Sink Bump Out
Q
Comments (7)
And a filler and end panel and blocking to the left of the DW to support the counter. The cabinet to the right needs an extended stile or filler if against a wall. And needs to have a finished end panel if exposed to the room. If this is an island, you've got to account for the plumbing and pony wall to the rear and how to finish that off. If this is in a wall alcove, I'd just make the whole run deeper and skip the posts. They add a LOT of expense and take away usable space.
...See More
Any ideas for a bumped out sink cabinet without columns?
Q
Comments (19)
I have a sink bump out with no flutes or columns and I think it looks fine. I don't see why you can't still have a 33" cabinet and just have the posts attached to the exterior front on the cabinet. Isn't that how they do it if it doesn't taper back? The doors will be smaller but the cabinet interior will still be big enough for you to have the sink you want.
...See More
jb1176
15 years ago
The other thing to consider is if there will be clearance for a garbage disposal (if you plan on having one). If there is no problem with the pipes, then I would think the sink base cabinet could be moved out the distance you indicate provided the sides are finished.
ni_2006
15 years ago
gemini16, I really like our sink bump out, and I am sure it is going to look great in your kitchen. I don't know much about plumbing to tell you whether it is going to work or not. My only advice is to make sure that the sink is brought forward as well to make it easy for you to reach your faucet.
oruboris
15 years ago
A lot depends on how your cabs are built, how the plumbing was done.

If all the plumbing comes from the wall, it's easier. You may be able to simply remove the back wall of the cab box, bring it forward, add a new piece of wood to fill the gap.
sue_ct
15 years ago
Just FYI, a standard sink bump out I think is 3". That is what mine is. Are you sure it would be worth it for 1 1/2"? I am not sure it would be as noticeable visually. Are you getting new counter tops and sink? If so, your sink hook-up would be in a different spot anyway, since the drain isn't likely to be located in the exact same spot as the old sink drain. You are likely going to need to re-plumb anyway, so go for it. I love the look, I think it is a little a more interesting. Many cabinets now a days, esp. if they are foreign made, have open backs. So you can just remove as much of the back as necessary as long as you don't cut into the frame if they are framed cabinets. If you run into trouble re plumbing the sink, it isn't usually too expensive to have a plumber do just that. I would guess about 100.00 around here. Not a large expense as far as kitchen renos go.

Sue
L H
Original Author
15 years ago
Thanks for all the input. Sue, ni 2006 did the 1.5" bump out and i really it like it. It give a little subtle interest. It sounds like it could be doable so I'll give it a shot.

Of course I just came from a home show and talked to more kitchen cabinet folks and flooring folks so i continue to have more ideas and confusion!!! I guess this is why so many people take months, even years, planning the remodel.

Happy Saturday.
sue_ct
15 years ago
I searched and found pictures of it. I have never seen a 1 1/2 inch bumpout before, it is more subtle but it does look nice.

Sue
evilbunnie
15 years ago
I think it all depends on how you deal with the unfinished sides of the cabinet. If it was not bumped out before, chances are that 1.5 inches that stick out is going to be the unfinished sides (often a different-color formica), and so you'll need to plan on covering that with matching trim. But perhaps you've figured that out already. As for the plumbing, I think your plumber can move the drain and faucet lines wherever you want, 1.5" is not going to be a big deal. Good luck!

Related Stories

KITCHEN DESIGN Kitchen Details: Out-of-Sight Paper Towel Holder

By Mary Jo Bowling

See how some homeowners are clearing the counter of clutter while keeping this necessity close at hand

KITCHEN DESIGN Where Should You Put the Kitchen Sink?

By Jennifer Ott Design

Facing a window or your guests? In a corner or near the dishwasher? Here’s how to find the right location for your sink

KITCHEN DESIGN Kitchen Sinks: Granite Composite Offers Superior Durability

By Rachel Grace

It beats out quartz composite for strength and scratch resistance. Could this kitchen sink material be right for you?

BATHROOM WORKBOOK How to Lay Out a 5-by-8-Foot Bathroom

By Mitchell Parker

Not sure where to put the toilet, sink and shower? Look to these bathroom layouts for optimal space planning

KITCHEN MAKEOVERS Kitchen of the Week: Rich Materials, Better Flow and a Garden View

By Jeannie Matteucci

Adding an island and bumping out a bay window improve this kitchen’s layout and outdoor connection

BATHROOM STORAGE 10 Design Moves From Tricked-Out Bathrooms

By Natasha Saroca

Cool splurges: Get ideas for a bathroom upgrade from these clever bathroom cabinet additions

WHITE KITCHENS Before and After: Modern Update Blasts a '70s Kitchen Out of the Past

By Mitchell Parker

A massive island and a neutral color palette turn a retro kitchen into a modern space full of function and storage

REMODELING GUIDES 10 Tips to Maximize Your Whole-House Remodel

By Ventana Construction LLC

Cover all the bases now to ensure many years of satisfaction with your full renovation, second-story addition or bump-out

REMODELING GUIDES Micro Additions: When You Just Want a Little More Room

By Bud Dietrich, AIA

Bump-outs give you more space where you need it in kitchen, family room, bath and more

KITCHEN OF THE WEEK Kitchen of the Week: A Classic Craftsman Gets a Colorful Twist

By Jeannie Matteucci

A key bump-out in the back and bold walls give a Seattle family’s galley kitchen better flow and a warm feel

Sponsored

J.Holderby - Renovations

4 Reviews

Franklin County's Leading General Contractors - 2X Best of Houzz!

More Discussions

Does anyone have Medallion cabinets in Maple Biscotti?

10

can anyone share picture of Silestone Lusso countertop

1

contractor chooses kitchen

33

Are counter installers covering a mistake?

8

Adding prep sink; single or double for cleanup?

1