you could use a damp mop. I would real than once they are clean. Since they are older, a wax finish may be the most appropriate.

Oops --- seal, not real the floors.

Unfortunately, we're not in a position to seal the floors right now. We don't really know what we would want to seal them with anyway, and it probably doesn't make sense to seal them before we figure out a way to sand them. I thought briefly about wax, but my when I told my mom about that she was horrified and said that her mother used to wax her floors, and the effort and build up and needing to take it all off as it built up was just horrendous and that's why everyone though wall-to-wall carpeting was such a god-send!

If we use a wood-floor cleaner, is it really going to hurt our wood? Especially if we plan on refinishing the floors anyway at some point in the future?

I have very old un-sealed hardwood [under my carpet now] but when I cared for them I would use vinegar and a well wrung mop. I also used paste wax and a buffer but if you ever intend on sealing them I would NOT use wax on them.
The nails and such should not be a problem for a professional floor company.
If you do it yourself you rent a walk behind sander that takes most of the guess work out of a nice level sanding.
I checked into having ours done and the price was well below the cost of carpet but carpet thru the house won out. [husband won]

Save your money and don't buy the fancy/schmancy products. I, too, would use the vinegar/water mix or I would use mineral spirits (rag and wipe) for cleaning. I would not use products unless I was 6 zillion percent sure that there wasn't wax in them...assuming you don't go the paste wax route.

Can you counter sink the culprit nails?

One way to check how thick your flooring is - remove a floor register if you have one or take off a small piece of quarter round and see the height difference. You can see how much sanding has occurred in the past.

I'd just use area rugs until you know how you want to finish the floors.

Would love to countersink the nails... we have a parquet floors, though. Each 12x12 parquet square is made of six individual slats, and each slat has six nails in it. So 36 nails per square foot of flooring covering about 500 square feet. Countersinking just ain't gonna happen!

I will use a barely damp vinegar/water mix from here on out.

Thanks for everyone's input!

K

My son is renting a large apartment about a building that is about 80 years old. He has wood floors in every room except the bathroom. They are very dull and need a good cleaning. Thanks for the tips about the vinegar and water. I think that would be the way to go. Since he's just renting I don't think he wants to invest in sanding and or sealing. But it would be nice to have it look "fresh" while he lives there.

I'm replying to this old thread instead of starting a new one with the hopes that someone can clarify things for me on this topic.

We're renting a house built in the early 1800s; well, part of it was. One room I know has the original wood floor because of the unevenly-sized very wide boards used. But in the living room and dining room it is newer, relatively. Thinner boards that have more consistent sizing. We were told that most tenants put in carpeting (either an oriental room-sized rug or a carpet remnant) in the living room and perhaps that has led to the wood floor in there appearing to be even more dull and almost dirty. We'll be here another 15 months at least but I'm not sure about buying carpet pieces yet.

Either way, I gotta clean this. Cat puke that we didn't find til morning; husband dropping a greasy piece of food; a bunch of things have happened that have left stains that just look like it's wet but it's not. I tried to cover the grease spots with salt right after it happened, I read that that might draw it out of the wood but it didn't work. I tried the Swiffer wet jet for wood floors on part of the living room - it didn't do anything bad but I don't think it did anything good, either.

So what can we do to :
1. Remove the stains
2. Make it shinier (bc the way it is now, it looks dusty & dirty even during the short time it's not!!)
3. Make it easier to prevent/clean up stains in the future

Thank you!!!

use baking soda and vinager to remove stains. it makes a bubbling action that you leave down for a few min then use a bristle brush and wipe up with a damp rag. you have to wait til it dries to see if you got it all

chinacat_sunflower:

Boy, am I glad to find this post! Could you share the ratio of olive and lemon oils to wax? And where do you find the bees wax?

I can't wait to do this to my floors!

Thanks!

You will be very lucky if chinacat_sunflower reads this thread, given that she posted that in 2008.

LOL. You got me there. I looked at the month, but not the year. . . Let's hope she recognizes my need for her knowledge! Thanks for the heads-up.

back in late 50's we had a family friend who had unsealed hardwood. her floors gleamed! she used a cotton mop pad and the old red furniture oil to give it an occasional once over. i have unfinished hardwood also and i mop it with water and a little mr clean. been doing that for 30 years. i oil on occasion..

I have 100 yr old floors that cannot be sanded again -too close to tongue & groove construction. Years ago, when we first rented, then bought 2-story house "as is" , floors were sanded and shellaced. The shellac still exists in corners but was gone from traffic areas after a couple of months. I've lived here for 50 years and covered main floors with scatter rugs. Due to several falls, I have removed most rugs, but the floors really look bad. A former housecleaner used Orange Glo on them before I realized what she was doing. I have cleaned them once with a Murphys solution. What can I do now to make floors look better that doesnt involve sanding or trying to remove any remaining shellac? It would have to be something I can do myself. .

Shellac comes off with denatured alcohol....which also cleans the floors....but stinks big time!!
I would use mineral spirits....and no Murphys....

thanks

Are there any tips for taking stain off of painted base boards? I'm buying a home where they obviously didn't care too much to finish the floor properly and I've got to get it cleaned and was hoping to seal it before moving in with my doggies and kids and furniture. Alas, I'm not sure the sealing will happen beforehand as the way things are going it doesn't look like I'll have enough time.

At any rate. Cleaning that stain off would be great. AND a "recipe" for the wood floor cleaning (vinegar & water, but is it 1:2 or 2:5? No one has said.)

Thanks!!! Crossing fingers for a swift reply!

Vicki