Sounds like there is something in the tank outlet, where the rubber hose connects to the outlet of the tank. Maybe a small nut, or seed fell into the fuel at some time, and rolls around until it gets stuck in the tank outlet! Or maybe it is in the hose. I'd say try another tank, using something suitable. A mower shop might loan you a tank to experiment with, if you leave a deposit (to return it when done!) If you replaced the rubber primer bulb, did you get the correct one? Some had a hole in the top, some don't, and one won't work where the other one does. Also, check behind the bulb--there are holes that might be plugged up, either by a bug nest, or dirt. Check the float in the carb if that carb has one. They do go bad, from water in the gas, which freezes and crushes the float, or get a leak, which messes up the carb. operation. What usually happens with gas not coming out of the tank, is-a mud duber wasp lays an egg in the gas cap hole, then plugs it up with poop, which hardens, and no fuel can get out! Which results in having the problem you have! But you say you tried removing the cap. Thats why i say i think you have something stuck in the tank outlet, or maybe in the carb inlet. If all else fails--take it to a shop and get it fixed! Rusty J.

I use this recipe for cleaning almost everything!! It works better than anything on the market today. Now watch somebody come along and say it's dangerous to mix ammonia and vinegar. They always do. I have used this formula for years and it hasn't exploded yet. The smell is a LOT less strong than some of the other cleaners. A couple of things I would add: I cut mine down to a quart so that I have clean water to work with more often. It works so well, a quart will do a big job. And don't try to store any left over mixture. This cleaner cost only pennies to make.

Boxers, thank you so much! You and two friends helped me today and now I have calmed down. One friend is visiting his daughter in Alaska so could not come by but he sent me a link on cleaning residue off hardwood floors and thought maybe it was residue from the product. Thanks goodness I think my friend was right since it looks like it is coming up. First I used the Bona Hardwood Floor cleaning to scrub over and over again with microfiber pads and the areas I was buffing dry seemed to look better. Then I thought I would go to Wal-Mart to buy the Windex with no Ammonia that was mentioned in the article to see if it worked better and it did. I will never use the Bona Wood Refresher product again! But I do like their Bona Hardwood Floor Cleaner product that leaves no residue. I have now spent the last few hours scrubbing the floor with so many microfiber pads and Windex with no Ammonia and whatever it was is coming off. I even washed a load of them and dried them as well as cut up a microfiber ivory blanket to get more pieces to dry with after I scrub with the Windex. I thought I had stripped my floors since they looked so bad. I have to go back and do the floors one more time on my hands and knees after this email but I am posting a reply as I eat dinner. My other friend came by who was local to help me for a little bit and then left but he was right I have to do a small spot and keep rubbing with the Windex and then dry the area with the dry microfiber mop. It is taking so long but I am determined to have my floors look good again so I can focus on my work tomorrow. If I can't get it all off (the floor looks 70% better after hours of cleaning now and my back is hurting), I will call the Bona company tomorrow. I do appreciate your email so much further calming me down. Tonight I am going to get a good night's sleep so I can work tomorrow with hopefully a floor that is pretty again with definitely no more dust on it and not having these blotches all over it looking so ruined.

The wipes are convenient, it does the job and I appreciate the lack of aerosol with that stuff. I was using 3M but this is not as toxic so we've switched off to it.