Lawn Tractor suddenly "pops" and squirts oil problem?

9 years ago

Hi there,
I have a 2 year old Craftsman Lawn Tractor, 21 HP, 42" Deck, model # 0917.28851
While cutting the lawn today I heard a "pop" under the hood and then oil started gushing from under the hood behind the air filter. I shut it down immediately thinking it was gasoline but it was definitely oil. I could not determine the source of the leak so I tried to re-start it hoping to find the source of the leak but it would only try to crank over once before nothing. It does not even try to start now when I turn the key, just one "ugh" and that's it. The oil stopped leaking once I shut it down so I assume it was squirting out due to the oil pump while still running? I did install a new oil filter 3 mows ago and it worked ok, but this filter (from Advanceauto) was made in china with no other identifying marks. The clerk told me it was a match to the old filter I brought in so hopefully that didn't blow it up? Any ideas on what happened or what I should look for to fix it? Hopefully it's not a lost cause after just 2 years!?
Thanks for any advice!

Sort by:Oldest

Comments (7)

whizzer75
9 years ago
When that happened to me on a Craftsman walk behind many years ago it had broken a rod and punched a hole in the cylinder.
Clean the oil off and look for a crack or hole.
rcmoser
9 years ago
Well that depends? when you changed the filter before did you see any sparkly stuff in the oil filter or in the catch pan when you drained it and did you put the right amount of oil back in it?

I would also take the oil filter back off and see if the seal failed or the filter and of course you can see behind it once the filter is off for hole in the block as suggested.

Sears Craftsman don't make em. Might want to say what brand/model number of engine? I suspect it's low end briggs or maybe K. Courage?

Only beings it two years old something went wrong? Usually they will last longer than that if owners do nothing, but put gas in it and on rare occasions check the oil level. That's why the two year warranty IMO of course. Grim!!!
Related Discussions
Lawn tractors, and the ones who operate them:
Q
Comments (7)
Yeah, their mother divorced their Dad about 8-9 years ago. She works long hours at the local hospital, and everything she buys is at the mercy of her two sons. The doors of the tin shed don't close, the swimming pool has collapsed, the Go-cart is rusting in the yard, and one son's 1986 pickup has been setting so long, the hornets have called it "home" for a long time! The tractor has never been squirted off, or any grass removed, and was a mess. I got it resurrected and it runs good again.
...See More
Motor Replacement 12/38 MTD Lawn Tractor
Q
Comments (3)
Tom Plum's answer seems most plausible, to me. If you find it is like that, just turn the flywheel backwards, and that gear should pop out, thereby freeing the engine to turn. This is usually caused by a low charged battery. Also, you don't have much of a problem of finding the exact replacement engine. I have changed engines in lawn tractors, and the only problems i have had are making sure the lower end of the crankshaft is the same size as the old one, and maybe having to change the throttle/choke/electrical connections.
...See More
How long before your CHEAP lawn tractor fell apart.
Q
Comments (147)
Here's my story: I've spent $700 bucks for 13 years of mowing. And I've been ridin' in the saddle. I mow about an acre, two or three times a month. I let the grass get a little too tall sometimes, but these mowers have had no problem cutting it down. My first was a Craftsman 14 or a 16 hp that I paid 100 bucks for. I only bought one battery in 5 years. It was probably from the 80s or 90s. The engine was still strong but the rest was shot. Time for a new one. So, I ended up calling a guy and he said "come on by, I have one for sale." He had a Murray he wanted 200 for. But I noticed a larger yard man sitting under a tree, it was a hydraulic 18 hp Yard Man that he said needed some TLC. I asked him what it needed. He said just a "little this and that." I've heard that before! Dig? I said, does it Run?" He said yes, and after some effort we got it cranked. I bought it. I just had a feeling about it. The quality stuck out. Hydraulics will last longer. I know a little something. But It was a little risky. I knew it needed a little help under the deck. I paid $225.00 for it. But 8 years later, it!'s still running. That Kohler engine is great. It's a 1996 model. It takes a little effort to get it cranked, I use a little ether and have a process, because I don't want to kill my battery with excess cranks.? I've spent $400 over the last 8 years on it. There's a pro mechanic who has put a belt on it. and some pulleys and such under the deck, batteries. I mow my lawn in 30 to 40 minutes. That saves me an hour versus the push type. Saves my back even more. My mechanic said the Kohler engine is as good as a Honda. This was a high time machine before I got it. I can just tell. But I've only put about 100 hours on it or so. I'm trying to stretch the life out by mowing only 2, maybe 3 times a month. If I mow every week, there's no need for the ether -- but I like for my grass to grow tall before cutting -- it keeps it thicker and better looking. My neighbors have a love- hate relationship with me.
...See More
Newer Lawn Tractors vs Old Lawn Tractors
Q
Comments (39)
reply by theodocus struck me as coming from the desk of the ad agency of MTD. No mention of the actual operation that involves rolling over uneven terrain and jarring action from bumps and uneven spots and the fragile fabricated axles that bend and crack easily. Oh, there is also the bushings used in place of ball bearings: bushing use requires higher horsepower to move the newer units. The Deere has points and condenser; cost $5.00 and 9.00 respectively and the sears is a solid state igntion. Newer technology is wonderful as long as it is coupled with quality assemblage in a product. I have a 1968 Sears GARDEN tractor with a 12HP Tecumseh Heavy duty cast iron engine with ball bearings and cut with a 42 inch deck and also have a 1976 John Deere GARDEN tractor with a cast iron 10 HP engine with ball bearings and cut with a 42" deck and use both alternately for mowing two acres and for tilling and moving earth, etc.. Each has cast iron axles and mutli-speed hi-lo transmissions and EACH is used for plowing, snowblowing, tilling earth, hauling 1100 lb loads in attached large carts. EACH will run circles around the new 20 plus HP light LAWN tractors made today. Spend 5,000.00 and you will have a comparable heavy duty GARDEN tractor. By the way, good luck on getting even 10 years of use with the new wonders.
...See More
bill_kapaun
9 years ago
Doesn't sound good-
On another forum that I can't mention without getting banned, there was an incident where the wrong filter was sold to the user.
A filter for a Kawasaki engine was supplied for a Briggs engine.
The gasket diameters are such that the Kawasaki filter gasket blocked the holes on the Briggs engine.
After some hassle, the user got a replacement engine from the auto parts store.

Briggs-
3/4" X 16 threads
Gasket 2.734" OD X 2.430" ID.

Kawasaki
3/4" X 16 threads
Gasket 2.475" OD 2.173" ID.
1saxman
9 years ago
What Bill said was my first thought too - wrong or faulty filter. Sometimes in vehicles, the old gasket sticks to the engine and when the new filter is installed over it, a catastrophic leak ensues. Don't know if this is possible with a tractor engine but the first place to look is the filter. It is possible that the correct filter properly installed could fix it, along with a new air filter (if it has a paper filter) or cleaning of a foam filter. Oil probably got to the filter, carburetor and muffler, along with the cylinder(s). If that's the case, the oil will have locked up the engine, being incompressible. Then you have to remove the spark plug(s) and spin the engine to blow it out. Once started, the engine will smoke heavily until the oil is burned out of it along with the carburetor and muffler. If all this goes well, the last thing would be a good cleaning of the whole affected area with a spray engine cleaner and hose it off. That's the best case - the other cases probably involve engine replacement.
A hydraulically-locked engine will bend a connecting rod right away or send part of one through the block. Here's hoping its just a filter problem with no internal damage.
vgkg Z-7 Va
Original Author
9 years ago
Thank you all for responding. I've been off the web since posting the message so just got your answers now. I will check out everything you suggested but I can say that when I changed the oil the old oil didn't appear abnormal (metal filing or anything) and the new filter appeared identical to the original filter in every respect, size, gasket, threads, etc. Once I get into it I'll return here to report the results. Thanks again for your advice, if it's the engine that failed I hope that Sears will compensate me on a new mower purchase, if they don't I will look elsewhere for a new one. 2 years = $1200 is not worth it!!!
vgkg Z-7 Va
Original Author
9 years ago
OK, after taking off the oil filter I could still not find the source of the leak (mower still gives just 1 "ugh" when turning the key, nothing more, sounds locked up). The filter itself was intact with no sealing problem and gasket is fine. But I did find a piece of metal (brushed aluminum) that was laying on the engine housing support just below the filter. This piece is about the size of a fingernail but I could not find where it broke off from. It's the same metal material that makes up the motor housing so I do think it's shot with perhaps a busted rod? I'll be going to Sears tomorrow with the chunk of metal and explain to them what happened, will see what "options" they offer me, if any. If they say "tough luck" I'll be looking for a new tractor elsewhere.
vgkg Z-7 Va
Original Author
9 years ago
Final wrap-up....
Sears treated me right with a really good replacement offer, much better than expected. The problem was definitely a engine defect with busted rod so that mystery is solved and case closed. Thanks again for all your advice!!!

Lawn Tractor suddenly "pops" and squirts oil problem?

Comments (7)

whizzer75

rcmoser

Related Discussions

bill_kapaun

1saxman

vgkg Z-7 Va
Original Author

vgkg Z-7 Va
Original Author

vgkg Z-7 Va
Original Author

COMPANY

BUSINESS SERVICES

GET HELP

CONNECT WITH US

Lawn Tractor suddenly "pops" and squirts oil problem?

Comments (7)

whizzer75

rcmoser

Related Discussions

bill_kapaun

1saxman

vgkg Z-7 VaOriginal Author

vgkg Z-7 VaOriginal Author

vgkg Z-7 VaOriginal Author

COMPANY

BUSINESS SERVICES

GET HELP

CONNECT WITH US

vgkg Z-7 Va
Original Author

vgkg Z-7 Va
Original Author

vgkg Z-7 Va
Original Author