Let's hope!

So many regulars have left.

Nice video, tmc2009! I saw a juvenile male hummingbird here in SE coastal MA on October 21, 2016. He hung around my feeder until October 29, 2016 and I didn't see him again. I asked a well-known ornithologist about this and he gave me a lot of information on late-migrating ruby-throated hummingbirds. If you scroll down to the end of this link Hummingbird Spring Migration 2016 you can read a quote from him discussing the issue. Bottom line is that the hummer may be genetically programmed to migrate late (or could be injured) but may still be able to migrate safely when she decides to leave. Claire

Presumably the panel you have on it is the same as the original. Keybuttons to access diagnostics functions are different on the various panels. -- Machine turned off. Press/hold Auto Dry Down, then press Power at the same time. Release both when the panel activates. Press Power to exit diagnostics. Or disconnect the power cord for several seconds. There are several levels of diagnostics. Most of them are for engineering development and factory testing, not useful for operational troubleshooting. Auto Dry Up and Down buttons switch between levels. Initial is level 0. -- Last Fault is level 3. Press Auto Dry Up three times. Fault code is displayed in binary via the Drying Progress LEDs. There are 22 fault codes so I'll list them in following reply. -- Sensor bars test is level 5. Press Auto Dry Up two more times. Or exit Diagnostics, start over, and press it five times. Touch a damp cloth or your fingers across the sensor bars, the pattern of LEDs on the panel should change as moisture is registered and then dissipates when the bars are not touched. There is a Data Download mode for use with an optical reader tool. I imagine you don't have one ... but it's accessed by entering diagnostic mode and pressing the Regular cycle button. The reader is placed at the red Auto Sensing LED. There is a Showroom Mode, which flashes the panel LEDs randomly to attract attention in a store display. Cycles can presumably be set but the machine won't start. Disconnect the power cord or toggle the breakers off to exit Showroom Mode.