I just stumbled upon this discussion and felt compelled to make my contribution. I know brick because I work for a brick manufacturer. However, I will try to keep my personal bias at bay. The first issue to address is durability. When installed properly, either option will provide many decades of service. Both materials have the compressive strength and moisture absorption ratings to withstand the harshest climates nature can throw at them. There is actually another factor affecting cement pavers, but since it doesnt actually cause failure of the unit, I will address it in the appearance section. Either way, make sure your bricks/pavers are designed to go in the ground. Not all cement materials, nor are all bricks designed to do this. It was mentioned that the deterioration of house bricks in a patio was unheard of and that it would actually be an advantage to find reclaimed bricks from a demolition project. DO NOT DO THIS! For a segmental paving material to withstand Mother Nature, it must have a minimum compressive strength of 8,000 psi and a maximum absorption rate of 7% after a 24 hour soak in cold water. I have seen historical test data from the mid 1900Âs that showed that many solid house bricks (which were often used mistakenly as pavers) had compressive strengths around 5,000 psi and absorption rates in the double digits! Needless to say, those ill-fated patios are either long gone or a horrible eyesore now. Now that you can be comfortable in choosing a durable product, the second issue to address is appearance. Additional factors besides just the look of the brick/paver should be considered. For instance, do you want your pavement to match the colors of the bricks on your house? Will you be incorporating any retaining walls in your project? No matter how hard you try, you simply cannot match a clay color in a cement product and vice versa. Brick makers do not currently make a dry-stack retaining wall system; therefore a brick retaining wall will require more work. However, if you are trying to create a stately atmosphere it may be worth the additional work (or hiring of a mason contractor) to build your retaining wall. The first factor of appearance, the look of the actual brick/paver does speak pretty much for itself. However, I do want to address some comments from the thread. To my knowledge (I have not researched this) cement pavers have always had their colors mixed throughout the paver. (End lack of research warning.) What is actually happening is fading due to ultraviolet radiation. This can be mistaken for the coloring only being on the surface because with time cement pavers will actually wear down. This is evident in a cement paver project once it has been installed for about 10 years. Because the erosion is visible (you can actually see the aggregate) it is commonly believed that coloring is superficial as well. I do not see the issue of erosion as a durability factor since the units will still be in one piece and the pavement system as a whole will not fail. (Personal bias warning in effect)However, after all your hard work and money put into your project, wouldnÂt you want it to look the same as it does now in ten years? (End bias warning.) To be fair, cement pavers can be sealed on an annual basis to ensure their color retention. However, when you add up the cost of initial construction and yearly maintenance over ten years, you could probably install solid granite for about the same cost. (I havenÂt done the math and may have exaggerated, so research it for yourself and see.) There are advantages for both products (Although one list may be longer than the other!) and your unique concerns and application should be considered. In addition, other pavement options such as bluestone and granite are worth researching and considering as well. I know this has been an extremely long reply, but I sincerely hope it helps you make an informed decision. While there are not as many "genuine clay paving brick" retailers as paver retailers, we are out here. Do your research and you will find us!

Sounds like it will be beautiful however spendy it may ultimatly be. How thick are the pavers? And you want to drive over this? We are also in Pa and I would be VERY leary about doing this. I know someone in eastern PA who did one inch thick slate pavers in concrete on their patio which was concrete. They are cracking- been in about five years. I have another friend who has a paver cobblestone driveway set in sand with a gravel base. This has been in about 15-18 years. Still looks good. If he's done this before and its held up - have him guarentee yours and go for it. Would be completely intallation technique sensitive.

GN Builders- I go to HD and Lowe's at least once a week. So far no go and both stores say they only carry the square. Neither can I order an oblong from them. sadly... Chispa and Virgil- I will try a landscaper. I have a friend who owns a small landscape company. Will try that route. Thx all for your offers!

There is a fair amount of information online regarding Cantera pavers online. https://rusticotile.com/cantera-stone-what-is-it/ Looks like a winner for the situation you described in your previous posting.