We went with the Delta Orleans line. We picked them out at the plumbing supply place with the contractor, but then I went online and found them cheaper. (Used Faucet Depot.) We got them in brushed nickel, but the chrome versions would be even cheaper. (Note that you do have to buy the handles separately.) In the guest bath they went with fixtures from Home Depot or Lowes. I do feel the difference between the two as the delta set is metal and then guest bath set is probably not. The guest set is by Moen - either the Banberry or Brantford. For all of them, we wanted one with a higher arc. They went with cultured marble tops with the integrated sinks. They did them at the current house over 15 years ago and aside from an accident with a candle, they look about the same as when they were installed. This was in the bathroom that my sister and I shared. We each had our own vanity and each morning we would sit on the vanity, with our feet in the sink, to apply our makeup. So, they survived lots of makeup spills, curling irons, etc. with no problems. We didn't have pure white, but it is white with grey streaks. This was dirty and the plastic was still on the counter and a cell phone shot that does horrible things to the way the cabinets look, but this is there guest bath vanity. I don't have a good picture of the master vanity, but here is a similar horrible shot showing one sink. Like the above poster, they haven't been in the new house long enough to say how they will withstand the test of time, but so far they feel very solid and we are very pleased. In chrome, the Delta Orleans is around $100 from Faucet Depot. This is the smaller centerset one. The wide set ones are going to be more, no matter which brand you go with.

Posted by bill_g_web (My Page) on Thu, Jun 28, 12 at 22:32 Love our wall mount - Kohler. Pay attention to spout length. My water stream hits the center of the sink drain - just dumb luck I suppose when installing. Faucetdirect.com search allows you to pick spout length. Here's my set up... http://www.billbblog.com/Diy/36/Vanity Was drilling out the mirror a necessity to have the mirror not be uncomfortably too high?

Here is the current Newport Brass East Linear. Maybe it was offered with different spout lengths.Here Here is one of the East Linear shower sets. I think it would work with your faucet even if yours isn't Newport Brass

Hello, my faucet is having a leaking issue, as well. However, it's a different type of faucet from what I am seeing here. Water actually trickles out the top where the lever is that you pull up to turn the faucet on. It also drips out of the spout. And the kicker is that when I open the cabinet underneath, there are big drops in three places coming down from the inside top of the cabinet where the bowl/sink sits. The stranger part is that I do not see any water on top of the cabinet underneath the bowl/sink. In other words, the inside is dripping as if there is a puddle in top of the cabinet which is causing it to leak inside. So there are 3 separate leaks 2 from the faucet itself and one from the cabinet top under the bowl. So I am basically sitting here listening to drips inside the cabinet and if left undetected a large puddle will form in the bottom of the cabinet. I hope all this makes sense, so I can get some help with this confusing issue. Thank you so much.