This old thread got revisited. @dani_m08 to answer the question about extra probe, I believe I ordered an extra one when I bought the set up. The probe wire is just setting in the junction box I think but honestly I cant remember. When I laid out the underfloor heating and the probe, I just ran another probe near the first probe, and it was then sealed into the floor self leveling compound as per instructions. then the end was just threaded into the wall like the one that would be live, and not connected, but just laying there in the box. Regarding the tile layout. I just decided to run it this way, after getting instructions on the 90Degree way, IIRC. The herringbone that I love is from my childhood and the side walks in my neighborhood that all ran at 45Degree. so that to me is herringbone. I know you posted on @sochi thread about her amazing bathroom and a wall mounted faucet. I would totally do it if I had the right sink for it. In my case I had made my sink out of soapstone and an integrated backsplash. The pictures of this bathroom reveal are no longer available because of the use of photo bucket, when it was Gardenweb. I did not keep my account with photo bucket. I'll add some of the reveal pictures so you can see the sink and floor. Regarding the sink there is no ledge for water to drip from my hands when using the faucet. The water drips right into the sink. In my other bathroom with a deck mounted faucet I am always wiping up drips and it is a nuisance. I much prefer the setup for this sink. Below: I love the flush finish from the faucet to the bottom of the sink. nothing drips on a counter or edge of a sink. Below: looking in from the doorway. Below: Here I am finishing up the sink. the backsplash was epoxied on as a separate piece. The whole soapstone install in the room took next to nothing to buy as they were all small pieces that I epoxied together with a 3 part stone epoxy. Below: this is the counter at the tub, and is in 2 long pieces but I was able to epoxy them together at there edges to make a wide slab for the top. All the soapstone was finished with a 60 grit sandpaper to be rough and this lovely soft tone of blue/green/gray/white. I did not oil it so this color tone would remain light. Below: If I recall correctly @sochi helped me decide on this Hubberton Forge Mirror. I have 3 different metals in this room, but they are all a cool silver to black color. Below: the center of this tower shares space with the kitchen on the other side of the wall. there is also some extra space that houses some electrical wiring. this is an old simple house. this bathroom was an add on when it got move to the farm in the 30s IIRC. The plumbing was all rearrange and some of the details that were orignially there I kept but updated it, such as this tower feature. The old one went and the carpenter did a wonderful job with this one. Below: This feature was another thing I kept from the old bathroom but flipped it from the other end and had the carpenter put drawers in it. Before it was a hell hole. things got lost and the build was soooo old and creapy I didn't like using it for storage. Now it is perfect for storage.

Hey Gibby -- 6 x 10 bath here [finally demo'd last week!] and I know that my size isn't even that small. I've been on the lookout for 3 or so years and it's been surprisingly difficult to find ideas. Aside from "recess whenever possible," of course! There's the "monochromatic = more spacious" school of thought but IMO there are alternative ways to lead the eye around the room and create interest in a small space. Things to consider: * color / color contrast * the lines of an object (round vs square) * judicious use of oversized scale * having some consistency with eyelines/sightlines of your vertical elements Here are some of the apparently-smaller baths I've found that put at least one of the above into action: We're adapting this built-into-doorway cab for our bath -- ours will be built out from the wall, perpendicular to the sink, and serve as a med cabinet. I'd use a wall-hung if this were a full bath, but I do love this! [Note horizontal cladding] I was involved in this [5 x 8 with TWO doors!] bath: Grabbed space from kitchen to make this 15" cubby: IMO one of the biggest challenges with small baths is to create negative space that serves to set off what IS in the room. In our case, we splurged a bit on a demilune/semicircle vanity instead of a square or rectangular one -- given our bowling alley dimensions, it helps carve out some pleasing curves. However, having lived in a place where the tiny wall-hung sink, toilet, and clawfoot were all accessible from one spot I know negative space is sometimes non-existent! I've enjoyed the book below, which has a mix of sizes and lots of materials in it --"ideas for tiny half-baths, medium-size his-and-hers, and large, luxurious home spas. Specifics on ventilation, waterproofing, faucets, showers, tubs, and more." Here is a link that might be useful: New Bathroom Idea Book (Taunton Press)

Thanks for all the responses. Went to a show room today and I don't love the shape of the Vespin. I'd only seen it online before so I'm either back to the drawing board or will compromise. Looking for very contemporary with straight lines like our current duravit (I think it's a stark). The guy at the shop is pushing an Icera; there are a couple different models that are aesthetically pleasing, the Muse being one of them BUT I can't find any reviews. Did a search on google and also on this forum with zero hits. Really don't want to go with something that I can't read about in terms of performance. Someone suggested the Toto Nexus -- we have this in our master and it's great and, if one can say this about a toilet, really attractive. Only thing is it's curved and straight lines make much more sense for the guest bath. So, wanting to stay in the $500ish or less range, can anyone recommend a well performing toilet that's very contemporary with straight lines? The Nexus with a rectangular shape rather than oval would be perfect.

The flooring store is going to request a sample of the following floor for us. I’m not familiar with this brand and it’s not one the store has worked with before, so any information or personal experiences would be appreciated!