When it comes to hardwood, trends are something to ignore! Why? Because hardwood is pretty much a lifetime purchase, and unless yours is damaged in some way, you're probably not going to replace it. So, light wood vs. dark wood, wide planks vs. narrow planks -- that stuff's all going to come and go. With that in mind -- as well as the very real concerns about cleaning dark wood -- I'll vote for a nice, neutral midtone every time. Not too much contrast, not too red, and (unless it's a beach house) not too pale. I think this is the wood that's most likely to give you good service and stand the test of time.

I'm curious to see the replies. My son almost bought an older house, 1951, the wood under the carpet is about 2"wide strips looks like solid wood, but seems to have a lot of nails. Is that how it was done back then? I wondered how it would look if he had them finished, but he backed out of the deal after the inspection. We are about to tear out decent wood because the sun has faded it and since it is not a big area it would cost a lot to refinish, and I hear the refinished floor would need to be done again much sooner than a new prefinished. I wish I could take out the old wood in a way that it could be used by someone, but I think it will get wrecked. The store I am using charges $3 sf to install it, the wood price obviously varies. They use their own employees, no subs, and did a nice job on our mbr and hall, so I will use them even though I dont know what an independent installer would charge. My maple will cost $5.54 sf, plus install.

My concern is the layers of vinyl underneath the hardwood. Hardwood doesn't like sitting on vinyl and vinyl doesn't like sitting on hardwood. The two do NOT like each other. If you think this is a good idea (which it is considered on the technical side of things a horrible approach to this) then you might have to add another layer of subfloor. A nice, fat, thick 1/2" plywood to cover those two layers of vinyl. Now you can go ahead and lay the hardwood. Technically, my suggestion is hideous. It is atrocious. It is so "unprofessional" that I could weep. But if you insist on leaving the vinyl in place, then you need to think of a way to separate the vinyl from the hardwood sitting on top....and one very sure way is with plywood. Again, my suggestion is a travesty. Then again so is laying hardwood over two layers of vinyl. In the flooring world, we 'allow' ONE layer of resistant flooring (like vinyl) to sit underneath another floor. For example: the first layer of vinyl was considered "OK" to lay another layer of vinyl over top. All good. No one in the technical department batted an eye. If a THIRD vinyl floor was proposed (or a laminate, or linoleum, or cork, or hardwood, or tile, or even carpet) it would be a "NOOOOOOOO! STOOOOOP! DON'T DO IT!" type of answer. So I will officially say: No. Stop. Don't do it. There. It has been said. That being said, if you as the homeowner choose to forgo the installation instructions and the "Best Practices" as set out by the National Wood Flooring Association (as homeowners your word is "law" when it comes to things like this), you are welcome to go ahead and lay hardwood over two layers of vinyl. If you do it, I suggest a new layer of plywood to help things along - because you need FLAT. And most "old hardwoods with two layers of vinyl sitting on them" are anything but flat. Good luck. You would be better off remediating the asbestos/vinyl and getting down to bare hardwood. Now a new floor (with the help of a layer of plywood) can go down. Or you remove the original hardwood with the vinyl (this is easier to do than scrape off the vinyl...and easier = cheaper) and start with a new layer of subfloor and go after it like it should be done. But as homeowner your word is "law". If you tell a professional to "just do it", they will say "yes ma'am/sir" and do it. But they will not warranty their work. You will be left holding the bag - and all the pit vipers that lay inside. It's your call.

Thanks. Jessica C. I have to agree with Sina that the grey-white wash wood floors are still selling, but not nearly as popular as they were a couple of years ago. Here is a grey floor with natural white oak under tone for your reference.