No, I haven't needed to service the washer or dryer at all. (It probably helps that I bought Mieles, as they've been trouble-free little workhorses. I'm opinionated about buying as much quality you can afford at the outset, to avoid problems later on, which has served me very well in this instance.) As far as accessing the dryer vent, I haven't actually ever done that. It vents down through a crawl space and out the foundation of our house. (You make me wonder however if it's time to go check on that, to see how much build-up there might be.) I don't seem to get an overabundance of dust, and am pretty meticulous about keeping the mesh lint screen cleaned after every dryer load, so that's probably helped. The washer is a tight fit, but can be moved. We need two people to actually pick it up (a couple of inches) to move it out, but have only needed to move it once in the time it's been there. (That was in the beginning when I had the sheet metal pan made, which took some time to procure and set into place. I also went the extra mile and bought metal mesh supply lines for peace of mind, knowing that moving the washer or dryer would take some planning!) The turn-off valve is at the back of the washer (behind the laundry basket) and rather hard for me to access as I'm short and don't have long arms. The Mieles are deep, rather than wide and because of this, I keep a step ladder (just in case) at that end of my home in my closet, so I can reach it quickly if the need ever arises. Hopefully it never will, but I did plan for the eventuality. This is absolutely some of the best space planning I've ever done. I can't tell you how easy it is to deal with laundry at this stage of my life...you'll just have to experience it yourself! If I ever have to move from here, I would repeat every detail exactly as is, in a heartbeat. Good luck!

A few years ago, I purchased EasyClosets systems to increase the utility of closets in a 1950's-era ranch. It worked out pretty well. The systems are easy to install (the hardest part is probably finding your wall studs, followed by cutting the metal closet rods to length - or vice versa, if you're not comfortable with a hacksaw), and they provided a lot of extra hardware for putting the pieces together. One closet really fought me on the installation of the top shelf pieces, I suspect because the back wall was a bit bowed, but the other three units installed without problem. I didn't order any components with drawers, as I just don't trust cam locks and MDF to provide durable, long-lasting drawers. The biggest problem I've had was when disassembling and removing a unit to repaint the closet, a cam lock got stuck and ended up breaking a pretty large chip out of one of the shelves. It's at a bottom, back corner so with a bit of epoxy it's barely noticeable, but it's a reminder of one of the drawbacks of that type of assembly. In use, the closets have proved very durable, and they made the closets a lot more functional. My preference would be to have a similar system in solid wood for my current home; I now have walk-in closets that could use some TLC, but I would be reluctant to remove the (paint grade, pine) shelving that's currently in place to install something other than another solid wood product, and I wouldn't mind adding some drawers or cabinetry where I would want some quality joinery as opposed to screws or cam locks. If you're going for pure "bang for the buck", Rubbermaid closet kits are a lot cheaper - albeit more cumbersome to install and a lot less attractive. The EasyCloset systems proved to be a selling point when we moved; they looked pretty much as good as new, the hardware components (belt rack, tie rack) are quite solid, and while the closet systems are recognizably melamine they blended quite well with the natural oak in the house, including the closet trim.

I live in NJ and used Contemporary Closets which is the not DIY division of easy closets. I had a great experience with them and they are significantly less money than California Closets. I had them do a walk-in closet in my MBR and then a few years later we decided to combine the walk-in and a reach in in the MBR into 1 giant walk-in. The designer came and was able to reuse all of the walk-in materials and then just added some on instead of starting from scratch. I would definitely recommend them. Here is a link that might be useful: Contemporary Closets

I have Elfa ventilated shelves (and some drawers) in my pantry and laundry room both. I love them BUT I use liners so I don't have the wobbly issue going on. That would drive me crazy. Elfa's ventilated shelves, unlike what you can find at Lowe's, HD or Ikea, have the wires a lot closer together. They also "lock" into place so the wire part is sitting really firmly in the bracket - not just a piece of wood sitting on top of the shelf bracket. As far as organizing little things, Elfa has "shelf baskets" that you can put dividers in and stack stuff in if need be. In the pic below, I have one of those on the immediate left (3 shelves up) and above the counter top oven in the back. I use it for bags of baking stuff like chocolate chips, coconut, etc on the left and treats in the back. And I absolutely love their big drawers. Container Store's return policy is great too - anytime with a receipt and the best Elfa sales is 30% off all Elfa products. It starts Dec. 24th and goes through the end of January typically. There is one in the fall that isn't as good - 25% of Elfa Shelving. (No, I don't work for Container Store, I am just a big fan and will be buying some more Elfa stuff during their Dec. sale.) Here's a picture of our new pantry.