Thanks Mitch! I prefer that size for my sofa in case I ever need to take a catnap. :) Blubird, I sure wish I knew to buy a couple of inches smaller in the cover before I bought a pair. Seriously, does anyone know of an online store that sells a lot of textiles, like pillow covers with many colors and patterns to choose from? I'm looking for checks and plaids and they're really hard to find, or not the color I want.

Hi, and thanks for responding. Our old windows are 30 year old aluminum frame picture windows that were in the house when we bought it. We were hoping to replace at least the back of the house this year, but since we are currently updating our kitchen we thought we would start there. It has a small window and I thought a bow window would make the kitchen look larger and with casement side lites we could also have some ventillation. It is the casement that restricts some makers. The panes have to be so narrow that there is not enough room for the mechanism.

I doubt that you will find one that is 38" wide, but there are plenty of 36" side by side counter depth refrigerators out here that should fit into that space.

Front to back depth should achieve the same capture goal as described for side to side. Sometimes a hood can be mounted farther from the wall and a spacer applied at the back, thereby achieving a somewhat deeper effective hood. Effluent will curl off of a flat back spacer. If flow rate is high enough this effluent will still be captured as it can't escape into the wall. Alternatively, the back spacer can be angled between the back wall and hood entry to reflect upward. Keep in mind as you think about this that the plumes have velocity (more than a meter per second in some cases) and momentum. Momentum is conserved on reflection (accounting for angle of reflection equals angle of incidence relative to the normal, just like light), but overall momentum is degraded by friction with the air and enhanced when entrained in the hood flow. Cooktops and ranges placed against walls with counters on both sides and cabinets above them that drop down below the hood provide a certain degree of flow support as the air is somewhat channeled to the hood and the plumes are somewhat restrained at the sides. Along with an excess of air flow (relative to my suggestion above), you may find that most of the plume is still captured. I have an island configuration so I can only surmise the flow patterns that will likely occur, as informed by various schlieren photographs of commercial hoods that have been published. Hoods can be at any height, but given the plume expansion, have to grow in size the higher they are placed. Commercial hoods often have their apertures at 7 feet above the floor (four feet above the cooking surface), and are built commensurately larger and have appropriately greater air flow (and MUA to replace it). You want the hood to be high enough to avoid head interception, as well as high enough to provide clear sight-lines to the interior of pots. I recommend drawing a side view sketch to scale of the cooking configuration, and add a stick figure cook. Observe sight lines and head vs. hood as the figure bends at the waist. This lends itself to experiments with hood mounting, both in height and offset from the wall. My Wolf pro island hood base is at 34.5 inches above the cooktop for a variety of reasons, and it just clears my head. Hoods that don't extend so far out may still miss one's head due to bending effects. At worst, head interceptions will train the cook to avoid the hood. :) At max power, the zero static pressure flow rate is 1200 CFM. Mounted In the hood, duct, or roof with pressure losses from baffle restrictions, hood transitions, duct losses, and in particular imperfect MUA, the actual flow would likely be closer to 800 CFM. This is higher than the 560 or so nominal flow rate needed for your newly described aperture, so you should have some margin unless the MUA is inadequate, in which case the house pressure will drop some and the flow rate from the blower will match the MUA that results from the MUA design and the pressure the house drops down to. Carbon monoxide sensors become desirable in such cases if there are combustion appliances in use. kas