My cousin is very good with caulk and a syringe - he caulked the other places where he had to cut the drywall to put the trim up. But those were light-colored (Navajo White and Thornton Sage) walls, we didn't bother to paint after caulking. I'm afraid the Antique Jade walls would have to be repainted after white caulk was applied, it might look worse than just leaving them with the slight gap/shadow? As I said, it's only the top 9" (and hopefully the TV will distract the eye). Panels are 42" wide, so the top won't have any pleats, will be straight since the single windows are 41" wide casing to casing (and 41.75" from edge of casing to end of stool on the other side). I'm wondering if I can even use a single panel on each (maybe add fringe on the inside edge to widen it just a little?). I only have 6 panels for the 3 windows - and these are discontinued. I had planned on 2 panels per window, plus valance, but that was before I discovered this forum! Maybe I can find a seamstress to cut 2 panels in half lengthwise and sew them to the other 4 panels to make each panel 63" wide instead of 42"? The panels will always be swagged back, I don't need them to actually cover the windows since I have the Romans there for shade/glare. Even if I didn't swag (put 2 panels on each window as originally planned) and didn't use the valances, I would just hang them from the clips in a stationary position. But I don't think I can use a panel on each side of the single windows with the TV there - I only have 7.5" between the TV and the window casing on each side, and I don't want the panel right up against the side of the TV. Maybe split the difference and have the panels hang 3.25" from each side of the TV (which would put the finial tips almost directly above the edge of the TV, about 28" above)? The valances are 55" wide, so if I just put the valances on the decorative rods and then put another rod under for the panels I think I might be able to "fudge" a single swagged panel on each single window and the valance would cover the casing on the TV side? Don't pay any attention to the size of the rod in the picture, this is the 48-86" rod I had open (to check against the 82" window) - the 28-48" rod is over the kitchen window but can be switched out so I have the same rods on both LR single windows. So I *could* fudge it to have one panel cover the rod b/t finials, as I said that would barely cover the trim though. In fact, straight out of the package (not pressed) this looks a little narrower than 42". Here's the table I was thinking of to put DVD player on (baskets with DVDs underneath), it's a little tall (32" compared to 28" desk there now, 28" window stool) so TV will have to go a few inches higher to fit DVD player under it if we put it on top of table and mount TV on the wall. The TV would be a good height sitting on the table, but then the DVD player would be way down by the floor and I couldn't fit my 3 baskets of DVDs. It's also 55" wide so will be touching the casing on either side (hoepfully will clear the stools) if we put it all the way against the wall, but we could pull it out an inch if it slightly overlaps. Is that too big? Of course, then we *really* don't have room for panels b/t the TV and the windows b/c they'll be behind the console table. http://s7d4.scene7.com/is/image/ASF/690864_S?$lg$ This matches our end tables, I'm not using the coffee table so thought I'd put DVD player on that and mount TV a foot higher, but the coffee table is 28" deep and that seems too deep to keep forever. We'd have to wait until April and drive down to DC/Williamsburg for vacation, bring the sofa table back with us since American Signature doesn't have stores in our area. I wish I could just cut the back 10" off the coffee table and put the back legs back on, but it's mortise and tenon. Maybe cut it and just support the back with a cleat on the wall, only have front legs? I think I need PS help - super squirrel, where are you LOL?

I like the far right one as well. Much will depend on the kind of light the room gets... Here's what I do. When I've narrowed down to three colors, I buy tester pots and paint two mighty boards in each color. (6 total) then I tape them up in various spots...and always in one corner to mimic what the paint would look like in a corner. My local paint store carries MB...but one can also buy them online. The are pricy---but work much better than posterboard. I keep them in a portfolio and they are VERY useful when helping friends with paint decisions. melanie Here is a link that might be useful: Mighty Boards.

I think the sectional is just too bulky for the room.. would it be that bad to leave the TV over the fireplace? what are the actual room dimensions? If you hang the tv on the short wall you need to have a way to watch without straining your neck.. what is the width of the room from fireplace (with the hearth) to the wall? option 1 - get rid of the sectional (yes it is comfy but bulky) and put a sofa facing fireplace, get 2 swivel chairs (recliners or not) to either face the tv on short wall or swing around and face the 'people' sitting on the sofa and a narrow ottoman for additional seating.. sketch the room on grid paper with as exact dimensions as you can.. option 2 - leave the TV above the fireplace but i would still replace the sectional with a sofa and chairs so you have more walk through space and the ability to move the chairs if you need to.

You are exactly right about the busy design on the credenza. That is exactly why I was thinking of something less busy with the molding trim. Do you have any thoughts on what to do with the wall?