SHOP PRODUCTS
Houzz Logo Print
tpar0tro30

Casting concrete to repair rubble foundation?

Frank
7 years ago
last modified: 7 years ago

I have a crawlspace that leaks air badly in the winter and I would like to insulate (I live in Minneapolis, MN for reference). Upon embarking on the job, I uncovered a rubble foundation that is in need of repair. This foundation is part an old extension to the house and is of much lower quality than the original limestone brick foundation. It also looks as if it has been repaired at least once in its life as there are some random chunks of red brick embedded in the wall which I doubt were original.

I understand that the usual repair would be to tuck-point new stones into the foundation, but because the access is so difficult I am wondering it there are any other options. Access is via a small opening in the basement wall but once inside clearance is very limited especially since there are radiator pipes to contend with (see photo).
As far as other alternatives to tuck-pointing, would it be possible to build a form on the inside of the wall and then cast concrete into the void? It appears that this method was used at some point for other parts of the foundation (to the left of the corner in the photos) and so far it looks like it is in good shape. If this is possible, any suggestions on concrete type?

If casting concrete is inadvisable, does any one have any other suggestions?
Also, in the first photo you will see that there is a large void at the base of the dirt. The void is below the "grade" of the rest of the dirt floor so could just be filled in with dirt and rubble. Would this be a mistake? It would be next to impossible to tuck-point in this void without major excavation so could poured concrete be used here?

Lastly, in case it alters any of the advice, the crawlspace does not have any water problems. Our house sits atop and hill and has good drainage away from the foundation. Additionally, the specific wall in question is now located under a porch so there is next to no moisture on the other side of the wall.

Thank you in advance for any suggestions or advice.

In this photo yo can see the original limestone foundation on the far right, and then the wall that needs fixing to the left. The photo also shows the void at the base of the wall next to the light (where the large shadow is).

Here is the corner which is in the worst shape of the whole wall. To the left of the corner you can see what appears to be concrete cast against another section of the wall.

And here is the access, probably only about 18in between the floor and those radiator pipes. Width of the opening is probably about 30in.

Comment (1)