I few more details on the plans that I posted above: The raised beds along the fence would be completely separate from the fence, I'm not talking about heaping dirt against the fence or anything like that lol! Just building raised beds 2' wide and placing them against the fence so I can grow vertically as much as possible. I have a 50' roll of black vinyl coated chain link fencing (part of it is used to enclose the current garden) and I plan to repurpose it by hanging it along the back fence so I can trellis peas, beans, tomatoes, melons, whatever. I have been reading that growing vertically is one way to get more out of a small space. Since I have two medium sized dogs and I have learned the hard way that regular garden fencing or poultry wire isn't really sturdy enough, I was planning to buy some hog panels, have them cut in half, and have those go along the front of the beds to keep everything out. Hog panels are 34" tall and the bars are close together at the bottom and gradually get further apart as they go up. Each half would weigh about 17 pounds, so I can lift a section off as needed to tend the garden, then put it back up when I'm done. The design I came up with has a 4' tall 4'x4' fence post between each bed, about 2' feet out from the existing fence posts. The end pieces of each raised bed will be screwed into it, and once the 1' tall beds are filled with dirt, it should be plenty sturdy enough to support these panels. I also intend to have a piece of 2"x4" going between each of these posts and the actual fence posts to lend greater stability to both, and that will be the only thing that connects the raised beds to the fence. I thought it would be best to keep them totally separate to allow the fence to be worked on or even replaced later if needed, without having to remove the beds. The center beds would need a different setup for keeping out the dogs and rabbits. I had in mind some kind of enclosure that goes around the perimeter, with a gate at the opening. Most likely I would use the same hog panel idea so I could access the beds from the outside or the inside, or I could opt to leave part of it in place and use it for a trellis. I have thought about even enclosing the whole thing with heavy plastic to create a greenhouse for winter, and I could also use it to suspend shade cloth since the sun is a bit too much here in Oklahoma in the summer and it actually gets hot enough that the tomatoes stop setting fruit. The only thing I don't like about this idea is that it is right in the middle of the yard (actually, two of them, one on each side) though the dogs would have a blast running around them. Aesthetically, I think the perimeter beds along the fence would be more attractive and open, even with the smaller island beds added. I would probably put just low covers on those and use those beds for low growing crops since I would have plenty of space to trellis the taller crops along the fence. Thank you for considering my ideas and if you have any feedback or suggestions for me, please let me know! Here is a link that might be useful:

Hi Catherine, yes they will pupate in the enclosure with no problem. Probably on the side or top. I don't think the cooler weather will bother them much, since they are a temperate species. I'm not sure where you live, but Papilio polyxenes is indigenous to a large part of eastern and central North American and does not migrate. They over-winter as chrysalises. They will be okay outside, but will grow faster if you bring them inside into warmer temps. Since there are only 2, they would be easy to tend inside in a smaller container if you prefer. Yours may not emerge this fall, but instead hibernate over the winter in their chrysalises. I'm still trying to figure out the best way to over-winter Swallowtails - I've got both Black and Spicebush swallowtails that will be over-wintering this year.

We have a sloped ceiling in a bathroom we recently renovated. I took the tile up the the lower side of the slope. This is how it turned out. I like having the higher ceiling in the shower.

Don't worry, I'll be going out of my way to salvage as many pieces of tile I can. The local salvage place doesn't take used tile (only surplus unused tile), but I'll offer it up on Craigslist to a DIYer - I'm sure there are plenty of hipsters who would LOVE to get their hands on vintage subway tile.. Same with the colorful glazed tile on one of the bedroom fireplace hearths - tile is loose and many are broken, and with those tiles having not been made in probably a hundred years, I can't repair it without it looking like a janky patch job. They would be fantastic as accent pieces in a kitchen backsplash or in a mosaic art piece. Luckily in these parts, all the houses are old and folks love nabbing your cast-off materials for their own projects, so I'm not too worried about the tiles being lost to the landfill if we don't reuse them ourselves. Now I need to start researching and perusing materials. Definitely want to avoid the obviously contemporary pillowy/beveled tile. Luckily, those little hexagonal porcelain tiles are kinda back en vogue, so hopefully I can get my hands on some equally tiny non-beveled ones. Depending on the design, might do some black accents/patterns. As for my kitchen, they didn't do tile on the kitchen walls back then - all the cabinets (like the built in ones in butler pantries) were backed with beadboard, so I'll be doing beadboard for backsplash. Heh, if you want pics, I'll have to remember to dredge this thread up in a couple years. We're taking things slow with fixing this house up.