Not me personally but several have here. There are some issues with regards to using the correct parts for the thicker sink throat.

I have one in my shaw fireclay. No problems after five years.

cpartist, did you have to adjust anything to fit it? ive read some stuff about an extra long flange?

That's what I was alluding to. You'll need an extended flange.

Sorry I can't answer your question as my plumber put it in during a reno.

We are getting a shaw farmhouse sink and intend to get a disposal, but also want a strainer since the strainer will look better than the big hole of the disposal. Anyone find a strainer that fits the disposal flange? Ferguson Plumbing doesn't seem to have a solution.

I had a shaws sink with the 1hp waste king and there were no issues. The only thing was ( as noted above), I had to get a deeper flange due to the thickness of the sink. I definitely loved the sink and were are going to put another one in in our new kitchen (we also had the smaller bar sink from Shaws). The only issue I had was marks from pots and pans that mostly came off and a couple of very small chips on the inside of the sink that I am not sure the cause, but perhaps they were from our cleaners. I am not sure if there are good ways to repair these items? But I still think we will do another pair of Shaws sinks again as they looked so good. We did have our cabinet maker install a piece of granite below the sink to prevent drips from damaging the cabinets. This made to so that drips coming down the side of the sink would fall to the floor and not damage the cabinets. This is an issue I have really seen with the painted cabinets and should be considered when designing.