If it is an LP kit for a Samsung dryer and you have a samsung dryer then it doesn't matter where you buy the kit.

mysteryclock I just had my Axxis dryer fixed once and for all. What an ordeal. Really would have been easy if I got the right repairman right off the bat. I've been all over this forum trying to figure out what has been up with my machine. I knew it wasn't right. It just took forever to dry and then eventually i kept getting this huge puddle of water under the machine after a while. It was drying sometimes and acting funny at others. Ultimately after 4 service calls and replacing all the parts on the entire dryer, it turned out to be the heater. For anyone with a condensation dryer, i cannot stress this enough- get your machine checked once in a while. I had 4 blissful years with it and it was telling me gently that something was wrong by slowly wigging out. If i would have had it looked at when it was just acting weird, I would have had to replace far less! I got a GREAT Bosch tech, who i would highly recommend to anyone in the LA/Pasadena area. It took me a while to find him but he fixed the problem in less than an hour once he diagnosed it. If anyone wants to have their Bosch or other German appliance fixed, call Ricky at Appliance Masters. I've heard some of their techs are not so hot. This guy was a senior tech and he was the best. After all the drama with this machine and service call after service call, i'd say this guy has a halo and angel wings! He fixed it in less than a hour once the parts were ordered. These high end German appliances are great unless something is off. I have had probably 5 repairmen with my various German appliances in the last 6 months. All of the good ones said the same thing- great appliances unless you are having a problem with them. I guess the moral of the story is- it's better to pay a bit to maintain and get check ups once in a while rather than wait until the machine goes up in flames or in my case out in a puddle of vaguely warm water. All it needed was a new heater, not a complete overhaul, which i wound up with anyway. In my house full of Gaggenau, Liebherr and Bosch, call me converted. I'm going to get these insanely expensive appliances looked at frequently so they stay calibrated. It seems to make all the difference in the world. I'm humbled and feel kind of bad that this was such a colossal headache. I still love my washer and dryer. It's the best purchase I've made, with a close second being the Gaggenau dishwasher. I love me some German appliances!!

Relocating water/sewer/power/vent facilities can be expensive. Unless you *really* have a need to move the machines from their designated locations, may be best to leave the configuration as-is. If you do want to make the move, get quotes and hire an electrician and plumber. Keep the dryer vent as SHORT and DIRECT to the outside as possible.

This is issue is now resolved. Despite the Whirlpool instructions to the contrary, I needed to remove the entire (1-piece) rear panel in order to properly access the vent ducting area. Once I did that it was a relatively simple procedure, just a little time consuming. I did need to shorten the section of vent duct protruding from the right side. Otherwise, the ducting provided in the conversion kit would have stuck out about 7" from the side.