I just went through this to hang a planter at my front entry. The stucco is like rock. You won't be able to bang a hole into it anyway. I don't think any adhesive will stick for long. I had to get a masonry bit and drill a hole just like the poster above me said. It took forever but I got it done.

Hi I had an experience with hot wet coffee grounds all down the back. It actually is really easy to pull out the drawer. Just pull the drawer out as far as it goes, then just lift the front up and out. Good luck!

Try this... http://youtu.be/sjBAMJ6Gz9Q MRB

Here is a link to a fairly common product, found in both steel and aluminum. http://www.timelyframes.com/trim/trims.htm To disassemble this frame. Near the floor, using a narrow blade screwdriver, pry the casing loose either on the opening side or the wall side. As the casing is loosened, work upward with the screwdriver. With about 18" loose, you can stop using the screwdriver and start rocking the casing back and forth while pulling out. With the casing removed, remove the door by removing the hinge pins. You'll find screws randomly spaced through the flanges under all the casing, remove these and the frame should be able to be lifted slightly so that the floor covering is no longer capturing the door frame on the bottom. If the door height is 6'8", when you reverse the swing, the hinge location will also be reversed and will be located where the the latch formerly was. If the door is a 7' and has not been undercut, the frame can be flipped, keeping the hinges on the same side as they are presently.