Thanks Sweeby! I did check your recommendation, it seems that they do not carry the pattern that I am interested in, but they do carry quite a lot of beautiful glass and options for the overall look of the door or cabinet that the glass is ordered for. Very beautiful way to finish a cabinet. I also posted this question on the Kitchens forum since there is far more experience with cabinetry over there and as I expected, I got a few more responses to my question. Here are the replies I received. They're very helpful, which is why I'm copying them here. RE: Have You Ever Heard of the Glass Inset Falling Out of a Cab D Breathe! The glass shouldn't fall out. If you're worried about it, however, there are little clips for securing the glass, and you can add more. You could also nail in a little molding bead. Most important, if you think there will be banging into the glass, get tempered. It costs more, but is harder to break and doesn't get as many shards when it does break. Check your local code. You might have to use tempered, or even wired, in a bathroom, by code, because people slip. I think my glass was installed by my cabinetmakers. They were here at the same time as the glass company was installing my BP backsplash, however, so I'm not 100% sure. Re glass shelves, it depends on what look you want, and what you're going to store. If you want the light to shine through the shelves, you must, of course, have glass shelves. For a beach or cottage look, however, you can just as easily do wood if it has a nicely finished side. Glass shelves might be better for a "formal" look. For a "formal" look, Reeded would be very nice. Glue Chip might be more feminine, however. Any simple, all over pattern would be good. I'd avoid anything that's figural, that is, no bamboo, leaves, raindrops, etc. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by mama_goose (My Page) on Tue, Jun 22, 10 at 14:15 Are there already plenty of mirrors? With several girls using the bathroom, you might consider another mirror in the door. Here is a link that might be useful: Mirrored cabinet doors thread. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by cupofkindness (My Page) on Tue, Jun 22, 10 at 14:20 Plllog: Thank you so much for your reply, it sets my mind at ease. Good, practical information. Here is a link to the patterned glass that I'm considering. I don't think it is tempered, however. I just hope it has a timeless appeal. My local glass shop doesn't carry this pattern, so I may have to buy it from the cabinet company, which I'd rather avoid. But at this point I just need to move forward. Any other opinions? What do you think of this pattern? Thanks again! Here is a link that might be useful: Morisco Glass RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by growlery (My Page) on Tue, Jun 22, 10 at 14:30 One can't say it would never happen. But it wouldn't happen without warning. You'd notice the joints getting loose, the glass jiggling or rattling, the cracks getting wider. This could happen over the years as a normal part of wear and settling. Just take it down long before anything happens, have it fixed put it back up and it should give you many more years of safe service. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by plllog (My Page) on Tue, Jun 22, 10 at 16:53 Cup, I think the pattern is pretty and girly enough, if a bit busy. It's not what I'd choose for "formal", but if you have some Victorian style elements, for instance, it should do well. You can have any glass tempered. The big problem with cabinet glass (as I discovered to my dismay!) is shipping, especially if the lengths are long. Do you live in or near a city? If so you can call around to see if anyone carries your glass. I first saw my glass at a place very near my house, but then they couldn't do it for some reason (I actually think "crazy" was in there somewhere). The cabinetmaker's glass guy wanted a humongous amount extra to have it tempered. Benheim, online, wanted the same amount because it would have to be crated and shipped by common carrier (like furniture) because it was too long for a parcel service. I had a very emotional week whining about it on GW. One of our members here was very helpful. He found a distributor within an hour's drive of me. Also that this pattern is all made by the same place no matter what the name and who sells it. I was in the middle of planning to use my GC to buy it (wholesale) but transport it myself to the temperer, when the GC had the thought that maybe he should ask his glass guys. (Ya think?) They were coming to install my BP backsplash (mirror), and they carry it, so they could just bring it instead of anyone doing any crating. Sigh. Such a simple answer! If you can't find a local shop that carries it, it might be best to let the cabinet company do it. They're crating and shipping your cabinets anyway. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by cupofkindness (My Page) on Tue, Jun 22, 10 at 19:49 plllog: Everything you've said makes perfect sense. Thank you so much for taking the time to post. And Mama Goose, I love those mirrored cabinets, they are wonderful. However, in this small tub/toilet room, when you step out of the tub, there would be the mirrors, and I'm not sure if my girls would be comfortable with that. I'll ask them what they think. It's a great idea, mirrors add so much to any room. Growlery, you are right as well, the glass wouldn't just fall out of the doors one day, we would have some warning.... now why didn't I think of that? Thanks again to all of you for your comments and suggestions. I am grateful for each and every one of them. ~Cupofkindness RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by vickimp (My Page) on Tue, Jun 22, 10 at 19:57 Yes! It happened to us. We have a large TV wall unit with a couple of upper doors with glass inserts. They were held in with plastic clips. Over time, the plastic fatigued and one day my DH opened one of the doors and the glass fell out onto the carpet. If it had hit his foot, or one of our kids, it would have been trouble. In our kitchen, we ordered some of our cabinets with glass inset doors. They came with those same plastic clips. Besides the safety issue, I didn't like the way they looked, so I had our finish carpenter redo them by gluing the glass in and then micronailing in a strip of wood matching the cabinets. Shouldn't go anywhere....I hope. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by cupofkindness (My Page) on Wed, Jun 23, 10 at 8:38 Vicki: Egads! I'm glad your husband did not get hurt. Was the glass tempered? I'm wondering if you can special order metal clips (those are what I remember seeing many years ago when I did my kitchen reno. The glass was held in place with rubber-tipped metal clips). Do you know what sort of glue your carpenter used? And the wood strip is a good idea as well... between the two I'm sure your glass is quite safe. I wonder what they did 100 years ago? Thanks again! RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by brickeyee (My Page) on Wed, Jun 23, 10 at 9:01 Very small quarter round was the standard for holding glass in cabinets for only a few hundred years. It still works very well. The only way for the glass to come out is if it is broken. In some cases you actually tape up the glass liberally, then break it if it needs to be removed. This makes it easier to salvage the thin strips without breaking them so they can be used again (important if they are finished to match). Plastic clips are an accident waiting to happen, as are any method that does not lock in as much of the edge as possible. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by growlery (My Page) on Wed, Jun 23, 10 at 13:06 Yes, I have some pieces of old furniture that have quarter rounds holding the glass in. Glass has been in doors and windows for a long, long time. Get good hardware, give everything a little wiggle every once in awhile to check it's in good condition, and there are many, many more things you do every day without thought that are more likely to hurt you, unfortunately. I believe, if this is really troubling you though, there is a 3M security product that is a film, essentially like a large sheet of, I don't know, tape or sticky Saranwrap, that you apply to glass, like doors. It advertises itself as being perfectly transparent, but is apparently not quite enough so for most homeowners. It probably gets blurry and little bubbles etc. But for your purposes, stuck to the back of a textured glass, it might be worth looking into. If someone did smash the glass, it would keep it most/all stick to the film, not loose. It might be a small investment in peace of mind. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by brickeyee (My Page) on Wed, Jun 23, 10 at 16:02 "If someone did smash the glass, it would keep it most/all stick to the film, not loose. It might be a small investment in peace of mind. " It is not going to help much if an entire pane of glass slips out and falls on your foot. RE: Have You Ever Heard of a Glass Inset Falling Out of a Cabnt D Posted by cupofkindness (My Page) on Thu, Jun 24, 10 at 9:21 My thanks to everyone for your replies and all of this helpful information. I'm going to the glass shop today to see what they offer in patterned and tempered glass. I'll keep you posted.

I think the only way I would consider having one would be if I also had another fridge with a solid door. It would look really cool to have folks over and have the bowls of salads and the incredible dessert sitting there looking at them with some wine chilling belwo, but who wants to see the dozens of bottles of partially used condiments and wrapped leftovers, etc.? I think the Subzero Pro 48 tried to compromise on that with the drawers below, keeping a commercial feel, but the use of the space isn't good for me -- or the price tag, and I couldn't even be tempted when they put the ice at floor level. I guess if you are going to spend that much opn a fridge, you ought to have no ice in it and have a separate icemaker. Silly me.

cawfeegirl: Yes, Cawfeegirl, you can have your cake and eat it too! You'll need either a miniDVI-to-HDMI adapter ($6.94), or a DisplayPort-to-HDMI adapter ($8.55), both available from monoprice.com, depending on which model Mac you have (older iMacs have miniDVI ports; new MacMinis have both; newest iMacs have DisplayPort only). With the proper adapter, you can connect a MacMini to any HDMI-capable display or TV. I actually misspoke in my earlier post--the preference would be to have a TV with two HDMI inputs and use one for your MacMini, and one for your CATV set-top box. Although a VGA input would also work (with the appropriate adapter), HDMI is capable of addressing higher resolutions than VGA, and is therefore preferred. When connected via HDMI, Macs typically automatically scale their display output to your TV's native aspect ratio and resolution (everything will look "right" without any hassle). dcwesley: Congrats! Many PC manufacturers are now making compact, all-in-one computers these days, some, even with touchscreens (which Apple does not yet offer). Many all-in-one, Windows-based PCs also offer significant savings over their pricier Apple counterparts.

Sorry, no pictures yet but I am going to have all those on one wall and yes, it was a little challenging to figure out where the microwave was going to go! We have an L shaped kitchen with island. The long wall with the appliances meets up perpendicular to a window wall with sink (and an upper on each side of window. There's also a sink on the island, which is parallel to the cooktop. We considered, but ultimately did away with corner cabinets in favor of uppers that meet in a right angle. Facing the wall we will have (from left to right) a microwave/oven/warming drawer stack, built in fridge, and upper cabinets flanking a hood. Below the hood is a full range. If you are willing to split up your ovens that way it's one way to solve the microwave dilemma. Depending on the type of range this may or may not be a more costly option. Toaster oven will be the only appliance I keep out on the counter. There's another wall across the room where I'll put the coffee "center." The other option would have been to go with a cooktop instead of a range, double ovens and microwave built in to the island. PS Not meant to be a hijack, but my dilemma with this particular configuration is what to do about the hood. Even though I really like side pullouts down to the counter, my instinct is that it would chop up the space too much and call attention to the fact that the range is not centered on the run.