Hi, First off, it's natural for the white coat of plaster to have spiderweb cracks all over the surface. These are only in the white coat and are very closely spaced and interconnected. By closely I mean 1/4" apart. _Those_ are nothing to fix or worry about. Cracks that extend into the base coat, and have movement that you can see by pressing, and seem "broken" are something to fix. I like to spray the cracks with bonding agent (garden sprayer) and sponge the stuff in (don't leave any drips of bonding agent; hard to skim over them). It seems to stop any movement for some time. Then add fiberglass mesh tape and the durabond routine, as you have read. The closet area, maybe sand the mess a little smoother to take off any high spots, the prime and then tape. We always use an oil primer around unknown/unforeseeable problem areas, because it really seals anything "bad" like wallpaper glue and prevents problems in the future, and durabond or regular mud sticks to the primer. Regular mud is not optimal for plaster repair in areas where is has to build up thickness; that's where you run into drying cracks (plus it takes lots of time for all the water to evaporate) and when/if it ever gets wet again it falls off lime plaster in sheets. It won't fall off if you oil prime first, and use it sparingly. Use brown coat plaster like Structolite (or Gypsolite), on top of a bonding agent like Link or Plasterweld if down to the lath, use durabond or easysand when the white coat is damaged or missing, use regular mud only for small imperfections and the final touchups, and you'll be fine. Casey

Hi Katie, my apologies for the delay in responding to your comment. I've been traveling over the holidays and rare access to a computer. I did end up caulking the gap between the baseboard and the wall. For cleaning gunk out of cracks, I'm starting to like using the bamboo skewers used for grilling that you can get at the supermarket. I had a batch of them in my cupboard and gave one a try and it worked so well, that I'm using them first in situations where I need something pointy. The bamboo is soft enough that it doesn't scratch anything, and I can dampen it and it'll pick up extraneous paper that's stuck in the crack. For some pieces of gunk in the crack, I also used a pair of needle-nose pliers, to extract the pieces. And, while I don't know if it's a bad thing to do, sometimes a piece of gunk would just fall more into the gap between the baseboard and wall, and I left it there. :-) I figured it would just get sealed under the line of caulk afterwards. Wear eye protection! Even if you don't think you need it, wear safety goggles, or at least your eyeglasses if you wear glasses. One day, I was caulking the baseboards in one of our bedrooms for the insulating value, and as I dragged my finger along, a chip of paint flew up off the baseboard toward my face. Since then, I always wear my goggles. About tips for caulking: - Do a search on YouTube for caulking. It really helped me to see videos of people actually doing it. - Get a good caulking gun. I got one from Lowes or Home Depot (I forget which one--I've been in and out of each so much these past weeks!) that was in the $10 range. I love its trigger mechanism. - Hold the gun at a 45 degree angle to both the wall and to the baseboard gap. I mean, this is in three dimensions: as you put the tube tip to the baseboard gap, make sure that it is a 45 degree angle between it and the vertical wall and a 45 degree angle between it and the horizontal-running gap line. (Hope that makes sense--it's hard to explain in words vs a picture. That's why the YouTube videos are so helpful.) - Do not make the hole in the tube too large when you cut it. The hole should not be larger than the gap you're trying to fill. And there was a post on one of these forums about tapering the hole that I thought was useful. While I can't find the posting this moment, I'll add the link when I locate it. Hope this helps! Lee

The raw materials needed to repair plaster walls & ceilings are relatively inexpensive, less than $200.00 per room. You would need basecoat plaster for the first layer, and a mix of gauging plaster, finish lime, and retarder, for the top coat. It is easy enough for a beginner to do a small repair, say one foot diameter. However, getting good results on an entire wall or ceiling comes with experience. How extensive are your repairs?

TimeLife is a racket---you sign up and never get loose. Go to a home improvement store---HD has a couple decent beginner type books. The local HfH chapter issues one to each new home owner---and I used to teach classes on things in the books. There are lots of different kinds of books there. Plus is that you can actually pick up a book and see the contents.