i agree, when you have a part of a combo go bad you toss the whole thing. or you can go pickup a 29.95 DVD player and plug it in teh AUX input. i had a JVC VCR a couple years ago would try to come on and then shut down. total cost of repair, including shipping was 100.00. i paid it the 1st time since this was a high end commercial grade unit that cost well over 500.00. the second time it did it i tossed it in teh garbage. if this had been and off the shelf unit, i would not even have thought about getting it fixed.

It could get very complicated if you are wanting to record tv on both a DVR and a DVD. Do you know for a fact that your DVD recorder has it's own tuner? If it does not, you will only be able to record the channel that your Dish box is tuned to if you can connect it to the Dish box. If it does have it's own tuner, then perhaps a splitter would do. To me, installing an amplifier/splitter on the incoming satellite feed would be the best way to approach this. Each device could then be programmed and controlled separately. We still need to know if there are enough inputs on the tv to accept multiple devices and what type they are. It might be possible to accomplish this with a splitter only, but you might need a satellite tech to determine if the signal loss by being split would be detrimental to viewing/recording.

They should be. Chances are both the DVD player and the Video Player use both use a Yellow RCA connector for the video signal along with Red & White RCA connectors for Stereo audio. It should be as simple as disconnecting the cables from the back of the video player and plugging them into the back of the DVD player. That being said, you really want to check if the TV has an S-Video connector. This cable would replace the Yellow RCA cable from the DVD player, and would be a significant improvement in picture quality.

I need help. I bought a new 42 inch screen Magnavox HD TV set. We are a member of the Direct TV Satellite Cable Network. The dish is outside of the house with a coaxil cable entering the home to a black box that sits beside the TV. A coaxil cable leaves the black box to a Power Surge Protector Electrical strip. Another coaxil cable leaves this connection to the TV back input area. The TV channels, volume, etc are controlled by the handheld Dish Remote Control. The Magnovox TV remote is not used. I have a Symphonic DVD Player and the red, white, yellow wire set and its own remote control. I have an Emerson VCR with a coaxil connector wire and its own remote controller. I do not know where to connect the VCR coaxil wire to the TV. The TV set has overall, 3 sites for the colored wire connection ports. (1) an area on the left side near the back of the screen for the yellow,red,white connection, and 2 separate areas called line 1 and line 2 connections (but a double set of plugs of red, white and yellow colored ports in this assembly)which is very confusing. Which row do I use? Goal: I want to know how to connect the VCR and the DVD. They are to be used separately. Do I hook up these 2 separately at the varied colored port areas, and they run independently with their remotes? Do I connect to the black box? Do I run the DVD through the back out hook-up of colored ports to the colored inports at the VCR front area and connect to the TV via a coaxil somehow?....Is the black box involved or bypassed? Please keep the insructions simple. The 3 sets of appliance directions are too confusing. I am having trouble with each appliance and the individual directions are not helpful to me with the currently used Direct TV Dish system. Thank you in advance.