Wow, thanks bumble doodle! Tt is great to know that the tub works well as a shower. We are tall too--at least most of us (two of my teenage daughters are twins and one is 5'2" and the other is 5'10", so maybe the short one complains a bit but that's ok, since she complains about everything!) We are getting the non-jetted version. Also, I am hoping that building the deck at the front will help with the water spray. I am pushing the tub back into an alcove under the window the long way (so we get into the tub at the 32" side rather than from the 48" side) and we are trying to go without shower doors in order to make the bath feel open. With a deck, we buy a few more inches of length to help avoid water on the floor. We may not succeed and will put a panel on if we have to. Any thoughts on this?

The Bain Ultra tubs (and I would think most airbubble tubs) are very low maintenance unlike many whirlpool tubs that need monthly cleansing cycles. Resale-wise I think alot of people are looking for a master bath with a tub that does something therapeutic, so I don't think it matters if it's air or whirlpool. If you're not worried about resale, I would say do what you feel is right for your lifestyle. Having the air gives you the choice of using the tub as a soaker or as a therapeutic option if your back is hurting, you've pulled a muscle, etc. With the soaker, soaking is the only option you have. I personally, like to leave my options open. Just my $0.02.

I had an acrylic pedestal tub in my last home, it was beautiful but it did not retain heat as long as I would like. Also it had to be reinstalled and I think they put some type of foam/cement in the base and then it did not budge at all. I also need to make a decision on a tub in the next two weeks and I will likely go with a pedestal acrastone tub ( American Bath Factory Nob Hill) . My first choice would be a victoria albert elwick if I had the space, I need 60" and I can not find a pedestal style I like in a 60" length with this company. Please post what you decide to go with.

As Nancy in Mich said, tubs should be installed on a wet mortar bed to support the entire bottom of a tub. The OP says they had special access cut in the closet wall order "to do that mortar"...but that does not sound like a thick mortar bed, which is what is needed. The mortar bed would be put down under the tub before it's installed, which after removing the old tub or shower base should not be a challenge. Some of the comments mention that their tub cracked even though sitting "directly on the concrete basement floor", so that would be what cause the problem in that situation. Tubs are heavy, tubs filled with water are heavier, tubs filled with water and a person are the heaviest of all.