I am in a similar quandary. Even after reading these responses, I can't understand how to set two separate start times on the same program, vs picking two stations to start together (which I realize really means sequentially). I understand I can't have four completely different regimes for my four stations (the controller only has three programs), so I've (reluctantly) given two zones the same plan. I also understand not to have the times of the different plans (A,B,C) overlap, as that confuses things. Here is what I want - can someone help me program my controller (it's a Hunter XC Hybrid)?! Valve (zone/station) #1: Monday and Thursday, start at 9:00 a.m., run for 9 minutes. Valves (zones/stations) #2 AND #3: Mon., Wed., and Friday, start time 6:30 a.m. for 5 minutes, and again at 8:30 a.m. for 5 minutes. Valve (zone/station) #4: Tue. and Sat. at 6:30 for 5 minutes, and again at 8:30 for five minutes. When I tried to set this up, I could set program A for zone 1 fine, but then when I tried to set up program B for zone 2/3, it was unclear how to include both zone 2 and 3. The instruction manual says you don't need to enter times for every valve, but how else does it know you want to include another valve? It also automatically included zone 1 in the plan, even though I had entered "OFF" when "1B" was showing. I thought this would be more user-friendly, but I'm pretty confused. I did a complete "reset" before starting to program it, as I'm sure I messed things up the first time. Now, I'm still not sure I'm getting it right. Thanks for your (detailed!) help!

I sure came to the right place. Thanks to all of you. Each reply was different, but either would have probably worked.I did the easiest thing for me and that was to pull the plugs on the printer and scanner, reboot and uninstall the software, even after a stern warning that I would be doing irreversible damage. Then I turned the computer back on and tried the scanner and printer. Both work fine, so far. I may have done damage that has not shown up yet. If I have a problem I may try the system restore feature. I had forgotten I even had that. Have had this computer for about 3 years and never tried the system restore.Thanks again!! Ida

yes, I have sp3. I had IE on yesterday(I want 7) Its on version 6 now and I cant get IE 7 back. It must not have un installed completely,as it says cant complete installation. I did a system restore. I am not knowledgable on much so I need careful and clear directions.

It's best to install on a warm day around 60 would be good once the liner is in the and water is going into it the night Temp will not matter...I always leave the liner inside before installation as much as possible to keep it flexable before installation.