The instructions to include a handy clickable link to the vendor are below. 1. First detail your experience with the vendor. 2. Click Preview Message 3. View your message, and make any corrections. 4. Open the site of the vendor in another window or tab 5. Go to the window or tab of the site, and place the cursor over the URL (address of the site), right click-the URL will then be highlighted....left click on copy 6. Go back to your message preview window, hover cursor over the Optional Link URL box and right click .... Then left click paste 7. In the Name of the Link box type the Vendor's name 8. Hit Preview once again...you will then be able to test your link to see for sure that it works. 9. If all is well, click submit And perhaps give step by step instructions on how to post a link? I am insecure (and computer challenged as well).. I know that sounds complicated, but so often things are really oversimplified, and of no value to someone who doesn't know about copying and pasting...I can remember not knowing how at one point. Anyone have suggestions? Want to rewrite? Start over? Is copying and pasting maybe different with different OS or browsers? I think some folks like to use a control button when copying...have never done that b4.

I would like to try those markers but I would think the edges of the metal would be very sharp regardless of how smooth you may be able to cut out the shape. I would be careful with the children/grandchildren even handling them never mind making them. I donÂt remember where on the internet I found this idea, but I made these markers last year and they held up well over this past winter. I suppose they could break and become sharp too. I need tall markers because I cannot see markers that are set too low.

Below is a link to the Suggestion at the Suggestion Forum. Maybe bow that the worst of the updating problems are over, they can address a few of the 'wants' with a lot of replies there. Here is a link that might be useful: Link to Rate and Review Forum

Just bouncing this down