Jon, I've had the opposite results here in the east. I've found that small, well rooted airlayered plants will establish themselves quicker than older, root bound plants which will often languish for years before kicking in. This may seem odd at first, but I believe it lies in large part to the root mass of the older potted fig. The root mass is tangled, crowded, and chokes on itself. The younger plant is still very vigorous and will send its roots out away from the center to establish a healthier plant. You might want to increase the root ratio over the aerial parts in your airlayering to see if this will help. A thick mulch will also help with the moisture in drier climates.

I'd get them in right away. Since they are not frost tender plants and haven't sprouted, you should have no problem. If you can't get them in the ground, pot them up, and hold them in a shady area until you have time to put them in. Good Luck.

Kristen, the reason why "damaging" the end of the cutting allows callusing is you're exposing the cambium layer, the juicy, lighter green layer just beneath the bark. This is the circulatory system of the plant and the tissue that differentiates, either forming more cambium to "knit" a bud to a stock or callus which further differentiates to form roots. Scarifying, or exposing more cambium by scraping off the bark to reveal it; smashing or crushing the ends to expose it or simply slicing through the bark to uncover more of it all have the same effect, though with varying results depending upon a variety of factors. The bottom line is, usually, the more cambium you expose, the greater the callus and number of roots. You might not have had good luck with softer wood cuttings possessing leaves because they transpire too much water, permitting the cutting to dry out. Traditionally, those with foliage work best in more humid conditions where they actually absorb moisture, keeping the cutting hydrated while it calluses and forms roots. Softer wood cuttings with a set or two of leaves are very successful under mist propagation. They continue producing chlorophyll, feeding the plant while absorbing moisture so the cutting continues performing as if it had roots, until it does. Often, this can be accomplished using Mel Hulse's Baggie Method http://paulbardenroses.com/hulse.html It also works rather well under more sophisticated greenhouse conditions. If your climate is humid and mild enough, it may work outdoors without artificial assistance, but I live in a more arid section of Southern California where outdoor propagation isn't successful without assistance. Are leaves necessary for success? If you're using soft wood cuttings during the normal growing season, and you have the right conditions and equipment, they make success easier, faster and more guaranteed. If you can't meet any of those conditions, they'll probably make it easier to fail. If the cuttings you strike with leaves fail with the foliage drying up, your humidity is too low when and where you're doing it. Where I am, they either perform as you've described, or if I put them under plastic, they mold and the cutting fails. That's why I have been so enthusiastic over the wrapping method. When done under the most appropriate temperatures with sufficiently hardened wood, it works like magic. Burying all but the top inch of a cutting has very similar effects and results as the wrapping method. You're keeping the cutting dark, cool and moist, all conditions required to stimulate callusing and rooting. After removing them from the wrapping when they are callused, and often rooted, I plant the cuttings deeply so the majority of the wood remains under soil for that exact reason. Why not? The suggested method of planting a bare root rose is to plant it then mound it with soil, keeping it damp, cool and moist until new foliage appears at the cane tops. At that point, you want to gradually expose more and more cane, permitting it to harden off to the elements rather than just stripping the soil from it and letting it fend for itself. The same is true for cuttings removed from a "close environment" of a baggie or greenhouse. They have to acclimate to the hotter, drier and sunnier conditions just as we do after being inside all winter when we begin spending more time in the hotter, sunnier spring and summer. Once I see growth beginning at the cutting tops, I tilt them out of the pots to check on root activity. If it's filling the bottom of the pot with roots, I'll raise it in the pot, exposing more of the cane by planting it higher, with more soil beneath it. If you can accomplish planting bare roots, uncovering them from the protective soil mounds once grow begins or putting the cuttings out higher just prior to or during a rain, it works excellently! The continual bath of rain helps stabilize them and harden them off very quickly, making your success even more of a sure thing. Kim

If they are growing well, you can harden them off and plant them now. Gradually take them out for a few hours every day, to expose them to more and more sun, until you are sure they can take it. It is good if they are in peat pots, so as not to disturb the roots. Otherwise, wait to be sure they have a good root-ball that will not fall apart when it comes out of the pot - this would be disaster.