If that soil is retaining that much moisture you may need to find out the why and correct that, if possible. Is this simply because of compacted soil and will lots of organic matter actually correect it? Is it due to a high water table and is it seasonal, and does this need major drainage done to correct the problem? Is this bed on the edge of a wetland and therefore is this drainage problem not correctable?

Melissa,your leafy fall cuttings were semi-hardwood cuttings, defined as mature stems from the current season's growth collected before the plant goes dormant. It sounds like you've worked out a good method for rooting them - at least for those roses that want to root at that stage of maturity. In my climate such cuttings started in October or early November need to be covered (as you do) or misted (as I do) and would have a good chance of rooting before winter sets in. I dismantle the misting system once the temperatures drop and leave the cuttings uncovered through our relatively mild and wet winter. In your climate it may be better to leave them covered, or maybe not. That's something you'll have to work out for yourself. Yes, you can take hardwood cuttings now. Or you could probably wait until you do your spring pruning and start some hardwood cuttings then. That works well in my climate. I stick leafless dormant cuttings a node or two deeper and don't cover them, but again, the level of protection required under your local conditions is something you'll have to work out for yourself.

Yeah one finished room. (Of course still full of dust) They finished our bedroom yesterday. Still have to enventually come back and do the closet, but for now have moved on to the great room. camlan..Their doing the same thing here. Running the wood with no seams from room to room. I hope ours eventually "glow" right now they just glow of dust, but it still is looking nice. judydel. I like to buy rugs at TJ Max HomeGoods. Patty Cakes.. Oh no. The stairs is what inspired us to do this hardwood job. We just finished painting the stairs yesterday. The carpet that was on the stairs was old, dirty and ugly. It had to come up. My kids are teenagers, so hopefully safety wont be an issue. We'll see if they become too loud, etc., we can always eventually add a runner to them. beth..Your floors, rugs and house are beautiful. Thanks for sharing the photos and experience. work.. Thanks for the advice. I'll remember this for the near future. Id love a sweeper I could run on the floor and not have to worry about damage.

My concern is the layers of vinyl underneath the hardwood. Hardwood doesn't like sitting on vinyl and vinyl doesn't like sitting on hardwood. The two do NOT like each other. If you think this is a good idea (which it is considered on the technical side of things a horrible approach to this) then you might have to add another layer of subfloor. A nice, fat, thick 1/2" plywood to cover those two layers of vinyl. Now you can go ahead and lay the hardwood. Technically, my suggestion is hideous. It is atrocious. It is so "unprofessional" that I could weep. But if you insist on leaving the vinyl in place, then you need to think of a way to separate the vinyl from the hardwood sitting on top....and one very sure way is with plywood. Again, my suggestion is a travesty. Then again so is laying hardwood over two layers of vinyl. In the flooring world, we 'allow' ONE layer of resistant flooring (like vinyl) to sit underneath another floor. For example: the first layer of vinyl was considered "OK" to lay another layer of vinyl over top. All good. No one in the technical department batted an eye. If a THIRD vinyl floor was proposed (or a laminate, or linoleum, or cork, or hardwood, or tile, or even carpet) it would be a "NOOOOOOOO! STOOOOOP! DON'T DO IT!" type of answer. So I will officially say: No. Stop. Don't do it. There. It has been said. That being said, if you as the homeowner choose to forgo the installation instructions and the "Best Practices" as set out by the National Wood Flooring Association (as homeowners your word is "law" when it comes to things like this), you are welcome to go ahead and lay hardwood over two layers of vinyl. If you do it, I suggest a new layer of plywood to help things along - because you need FLAT. And most "old hardwoods with two layers of vinyl sitting on them" are anything but flat. Good luck. You would be better off remediating the asbestos/vinyl and getting down to bare hardwood. Now a new floor (with the help of a layer of plywood) can go down. Or you remove the original hardwood with the vinyl (this is easier to do than scrape off the vinyl...and easier = cheaper) and start with a new layer of subfloor and go after it like it should be done. But as homeowner your word is "law". If you tell a professional to "just do it", they will say "yes ma'am/sir" and do it. But they will not warranty their work. You will be left holding the bag - and all the pit vipers that lay inside. It's your call.